Advertisement
Product description
Parts names
1
2
3
4
5
6
7
8
1
Hole punch for water bottle
2
Child safety switch
Hot water button
3
4
Ambient water button
Cold water button
5
Spout
6
Water collector grid
7
Storage space
8
(For some models)
5
9
10
11
12
13
14
9
Cooling switch
10
Heating switch
Power cord
11
12
Condenser
13
Outlet of cold water
Outlet of hot water
14
Installation
Placement
Use the appliance indoors, where is
no likelihood of rain or bad weather,
as there is damage risk to the product
electrical system.
The product must be installed in an
easily accessible location in case of
repairs.
Put the appliance on a flat surface
and keep a minimum distance of 25
cm from the wall. Make sure that the
ventilation openings of the product are
not being obstructed.
To avoid a hazard due to instability of
the appliance, it must be fixed in
accordance with the instructions:
1. Use 13 mm screw to fix the fixing
bracket on the middle of bottom
cover.
2. Drill out a screw hole(6 mm) on the
floor.
3. Insert a screw anchor (wall plug)
into the drilled hole.
4. Move water dispenser, Align fixing
bracket hole with screw hole of the
floor
5. Put the 25mm screw into the screw
hole of fixing bracket.
6. Tighten the screw.
Important
Do not install the water dispenser in a
location where there is a direct impact
of sunlight or near heat sources, as a
stove, oven, etc.
Warning
Do not plug in the device unless the
water bottle is already installed and
the system is full of water.
6
Advertisement
