Pelgrim GVWC290L/P03 Instructions For Use Manual page 178

Problem
Bad odour in dishwasher.
Grease deposits in the dish-
washer.
The dishes are not dry enough.
34
Possible causes
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in
corners.
Low temperature programs
have been selected for a pro-
longed period.
Low temperature programs
have been selected for a pro-
longed period.
The Combi drying option is
not activated.
The dishwasher is not fully
loaded.
Rinse aid needs topping up or
dosage is set too low.
The setting TAB is activated and
all-in-one detergent with insuffi-
cient drying effect is being used.
Action
Check that the yellow drainage
pump stop (on the right in the
bottom drain) is in place. See
the chapter Care and cleaning.
Check that the hose is free from
kinks and sharp bends.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner diamet-
er of at least 14 mm.
Clean with washing-up brush
and low foaming cleaner.
Run a program with a high tem-
perature once or twice a month.
Or run a self-cleaning program.
See Self-clean in the chapter
Using the dishwasher.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as In-
tensive 70°. Or run a self-clean-
ing program. See Self-clean in
the chapter Using the dishwash-
er.
Activate the Combi drying
option.
Fully load the dishwasher.
Top up with rinse aid or in-
crease the rinse aid dosage
setting.
Switch all-in-one detergents or
deactivate the TAB setting and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.