Pelgrim GVW221L/P01 Instructions For Use Manual page 30

ERRORS
Problem
Yellow or brown scale
on the inside of the
tub.
White scale on the
inside of the tub.
Dishwasher detergent
is left in the detergent
compartment.
Steam.
Black or grey stains on
the dishes.
Water remains under
the filters.
The dishwasher is
leaking.
Faults code E1
Faults code E3
Faults code E4
Faults code Ec
Faults code Ed
EN 26
Potential causes
Traces of iron in the water
may cause spotting to the tub
of the dishwasher.
Hard water.
The detergent compartment is
blocked by dishes.
When opening the door.
Aluminium cooking utensils
have scraped the dishes.
This is normal.
Rinse agent reservoir too full
or rinse agent is leaking.
The dishwasher is not
standing level.
Water intake time is too long.
Not reaching required
temperature.
Overflow.
Washing control system fail.
Failure of communication
between main PCB with
display PCB.
Should the appliance become overfilled or exhibit excessive leaking,
shut off the inlet tap and alert the service department. If all indicators
are flashing simultaneously: switch off the dishwasher immediately,
shut off the inlet tap and alert the service department.
Self-repair or non-professional repair may cause serious risks to the
safety of the user of the appliance and impact warranty.
If there is an error code that cannot be solved, telephone our service
department.
Solution
Contact a manufacturer of water
softeners for a special filter.
Increase salt consumption setting.
Load the baskets so that the dishes
no longer block the detergent
compartment. Clean the upper spray
arm.
This is possible at the end of the
cycle.
Aluminium can tarnish.
A small amount of water around the
drain on the rear of the tub base
keeps the seal flexible.
Take care not to overfill the rinse
agent reservoir. Spilled rinse agent
can lead to foam/flooding. Wipe up
spilled rinse agent with a damp cloth.
Adjust the dishwasher so that it is
standing level.
Faucets is not opened, or water
intake is restricted, or water pressure
is too low.
Malfunction of heating element.
Some element of dishwasher leaks.
PCB or motor fail.
An open circuit or break in wiring for
the communication.