Table of Contents
Advertisement
1. Press button Start/Pause
The related indicator flashes.
2. Change the option set.
3. Press the button Start/Pause
again.
The programme continues.
11.11 Cancelling a running
programme
1. Press button On/Off
programme and to deactivate the
appliance.
2. Press button On/Off
activate the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
11.12 The ProSense System
load detection
After touching the Start/Pause
button:
1. The ProSense System starts the
laundry load detection to calculate
the real programme duration. The
indicator
and the time dots flash.
2. After about 15 minutes the display
shows the new programme duration:
the indicator
dots stops flashing.
The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
The ProSense System
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
.
to cancel the
again to
goes off and the time
The ProSense System is not
available with all
programmes such as :Wool/
Silk, Rinse, SpinDrain, and
programmes with short
cycles.
11.13 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator
you cannot open the door.
To open the door proceed as follows:
1. Press the button On/Off for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the appliance door.
3. Close the appliance door.
4. Activate the appliance and set the
programme again.
11.14 Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Start/Pause.
The door lock indicator
2. Open the appliance door.
3. Close the door and press button
Start/Pause.
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the lid
locked indicator
The indicator of Start/Pause
goes off.
1. Press button On/Off
the appliance.
ENGLISH
23
stays on and
goes off.
goes off.
button
to deactivate
Advertisement
Table of Contents
