FJM security KeyGuardPro SL-500 Instructions

www.fjmsecurity.com
KeyGuardPro Lock Box
You can set a new combination for your KeyGuardPro any time by following the below
directions:
FRONT
BACK
Sample combination has
been set to 1965
www.fjmsecurity.com | info@fjmsecurity.com
Toll free 800-654-1786
[shackle mount]
Combination Change/Reset Instructions
1. KeyGuardPro does not come preset to any combination. For best
security, choose a combination between 4 to 7 numbers and/or
(b)
letters.
2. The first time you set the combination, press and release the clear
button (a)
3. Push down on the open tab (b). The KeyGuardPro will open,
exposing access to the backside of the faceplate.
(a)
4. On the backside of the faceplate, there are 11 yellow buttons
with arrows pointing upward. Below the arrows are numbers that
correspond to the numbers on the front of the door. If using a
lettered combination, find the corresponding numbers for the
lettered group.
5. Remove the white plastic combination change "key"
bottom. (Note: a small screwdriver can also be used).
6. Using the combination change "key" (c), push in and rotate each
number that corresponds with your desired combination 180
degrees until the arrow on the button is pointing down toward
base of KeyGuardPro. Do this for each letter and/or number in the
combination. (Note: Arrows on buttons must be pointing directly
down at a 6 o'clock orientation
or your combination will not
work.)
7. The shackle can now be opened
by pushing the release tab
(c)
(d)
inside the KeyGuardPro.
Once shackle is released, place
on door handle and secure
by putting back into original
position.
Continue to Step 8 on Page 2.
INSTRUCTIONS
SL-500, SL-501
to clear the combination and reset the buttons.
(c)
at the
(d)
Page 1