Subscribe to Our Youtube Channel
Summary of Contents for Hollywood Racks LBR-1
- Page 1 LED Light Bar Model LBR-1 Shown attached to Bikes Shown attached to Hollywood Racks model HR1500...
- Page 3 1. This product may be used with a vehicle side 5 pin flat connector, however there is no reverse light function on the LED Bar. 2. Hollywood Racks does not warranty or guarantee functionality of this product with any other type of adapter. 3. Warranty for this product is voided if the electrical cable is cut or spliced.
- Page 4 Installation of the LED Bar • Check contents of the box per the parts list on page 2. Test for vehicle’s trailer connector for functionality (use 4 pin flat to 7 way round if necessary) • Remove tester (G) from plastic bag (Fig. 4). This is a two-person task, someone will need to press on the brakes while the other person observes the LEDs lighting up on the tester.
- Page 5 Step 5: Wrap the canvas cover around the buckles and secure with the built in Velcro strap. (Fig. 8) Fig. 8 Fig. 9 Step 6: Remove two 1” Velcro straps (B) from the parts bag. Secure the LED Bar against the frame or tires of the bike. (Fig.
- Page 6 Installing LED Bar to Hollywood Sport Rider or RV Rider racks Square Tube Clamp Warranty & Fit Notes: The clamps included with the LED Bar are intended to fit all Hollywood Racks Sport Rider Racks, the RV Rider and the Destination E (requires adapter) racks only.
- Page 7 Step 5 continued: Note that the legs of the PVC housing clamp Fig. 17 should be inside of the hinged clamp before assembly. (Fig. 17) Step 6: Insert the 5mm carriage bolt through all four clamp legs, install the small lock washer set (Note we have included an extra two sets with the parts), and install the knob.
- Page 8 Hollywood Racks will remedy defects in materials and workmanship by repairing or replacing (at its option) a defective part without charge for labor or parts. Hollywood Racks may elect (at its option) to issue a refund equal to the purchase price paid for the product.
Need help?
Do you have a question about the LBR-1 and is the answer not in the manual?
Questions and answers