Elk HOME 52222/1 Quick Start Manual

WARNING: DISCONNECT POWER AT THE MAIN
FUSE BOX BEFORE INSTALLATION.
WARNING:
This fixture is intended for installation in
accordance with the National Electrical Code
(NEC) and all local code specifications. If you are
not familiar with code requirements, installation
by a certified electrician is recommended.
Before assembly, remove all parts and part
packages from box. If anything is missing, please
contact the retailer from which the product was
purchased.
1. Determine desired location for installing
fixture. Verify the location is close enough to an
electrical outlet.
2. Hold mounting bracket (A) so the holes in the
sides of the mounting bracket are on the left
and right. The sides of the mounting bracket
should be pointing outward.
3. Place mounting bracket (A) against wall at desired
position. Ensure mounting bracket (A) is level.
Mark on the wall the location of the two holes in
the mounting bracket (A). Place mounting bracket
(A) aside.
4. Using a drill bit the appropriate size for wall anchor
(H), drill holes in wall at each marked location.
5. Carefully tap each wall anchor (H) into holes in
wall.
IMPORTANT: Supplied wall anchors (H) are for
drywall. If your wall is a different material, use wall
anchors suitable for your wall material.
NOTE: Wall anchors are not needed if installing
mounting bracket (A) to wall stud.
6. Place mounting bracket (A) on wall. Align holes
in mounting bracket (A) with wall anchors (H).
Thread one wall screw (G) into each hole in
mounting bracket (A) and into wall anchors (H).
Tighten wall screws (G) to secure mounting
bracket (A) to wall.
7. Place backplate (D) over mounting bracket (A).
Align holes in sides of backplate (D) with holes
in sides of mounting bracket (A).
8. Thread one fixture mounting screw (E) into each
hole in backplate (D) and into holes in mounting
bracket (A). Tighten screws to secure fixture to
wall. DO NOT over tighten.
9. Pass hole in top of shade (K) over socket. Thread
socket ring (L) onto socket. Tighten socket ring
(L) to secure shade (K) in place. DO NOT over
tighten.
10. Screw recommended bulb (E12 candelabra bulb
type, not included) into socket. Verify correct
bulb wattage marked on socket of fixture.
WARNING: DO NOT exceed maximum bulb
wattage.
11. Insert plug into electrical outlet.
12. Turn power on to lamp using switch on
backplate (D).
ANY QUESTIONS CALL: 800-613-3261
Français p. 2
A
K
L
BULB
1
M-F 8:00AM-6:00PM ET
Español p. 3
ITEM#: 52222/1
G
D
E
SWITCH
elkhome.com
H
D