AAMP Global Stinger SPXWPRGB4D Manual

DYNAMIC RGB LED LIGHTED WHIP
with QUICK DISCONNECT
Before you start, read directions completely.
If your vehicle is not pre-wired for external lighting,
you may need the following:
Inline Fuse Holder (SPXATC16 or similiar)
5 Amp Fuse
2 Strand Primary Wire
Wire Connectors / Solder
Wire Cover
Zip-Ties
Optional:
Switch
Relay
The SPXWPRGB4D Dynamic RGB Whip requires a
Dynamic RGB Controller which is sold seperately
1. Mount the base in desired location. The
base requires a 1/2"/ 13mm mounting hole.
2. Connect extension wire to the Red and
Black wires and route wiring to the battery or
switch / relay location.
3. Refer to diagrams for wiring.
Diagram 1: Wiring direct to power and using
remote control to turn on/off. Must add 3
AMP fuse on RED 12V+ wire.
Diagram 2: Wiring with a switch. You can
add a new dedicated switch or use an
existing light switch that outputs 12V+ when
ON. You will need to add a 3 AMP fuse on
the RED 12V+ wire and also requires a 12V
relay.
4. Attach whip and test.
To attach or release the whip
from the base, pull up on the
locking collar.
SPXWPRGB4D
WHAT'S INCLUDED
4' Dynamic LED Whip
Mounting Base
Flag
Zip-Tie for Flag
Mounting Base Cap
Diagram 1
5
AMP
FUSE
Dynamic RGB Controller
Sold Seperately
Diagram 2
5
AMP
FUSE
87
12V+
86
87a 85
30
Dynamic RGB Controller
Sold Seperately
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
O O O O O O O O O O O
ON