Homebase EDIT Instruction Manual

2022-11-10 / Homebase EDIT
644693_Instruction manual
SOLAR ULTRA BRIGHT PIR LIGHT
ASSEMBLY AND OPERATING INSTRUCTIONS
These instructions are for your safety. Please read through them thoroughly
before use and retain for future reference.

COMPONENTS

• 2 x screws
• 2 x wall plugs

HOW YOUR SOLAR MOTION SENSOR LIGHT OPERATES

During the day, the solar charge panel included with this solar LED PIR light
converts sunlight into electricity, recharging the batteries. Using this stored energy,
the LED lights turn on automatically at night, when motion is detected.
The light works with a built-in PIR (Passive Infrared) sensing device, which is
continuously scanning for a heat source moving in its detection scope. Once a heat
source (such as a human or a car) is detected in that area, the light switches on
immediately, and automatically, to illuminate your pathways, steps, patios, porches or
anywhere you select for safety, convenience and security. The light remains on while
the moving heat source stays in the detecting scope.
• Motion activated
• White LED stays on for 30 seconds

CHOOSING A LOCATION FOR YOUR SOLAR MOTION LIGHT

For optimum sun exposure and longer light
output, place the solar panel in a position
that receives at least 8 hours of direct
sunlight per day. Placing the solar panel in
a shaded location will not allow the
batteries to fully charge, and will reduce
the operating hours of the light. When
choosing a location for your solar
Solar panel
Battery case
Screw
Sensor
Lights