Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Sensor module
Bolt
Nut
Washer
Mounting bracket
Wire harness
Fuse
Slope decal
Fuse decal
No parts required
No parts required
Determine the left and right sides of the machine from
the normal operating position.
Preparing the Machine
1.
Park the machine on a level surface.
2.
Disengage the power takeoff and lower the
attachments.
3.
Engage the parking brake.
4.
Shut off the engine and remove the key.
5.
Wait for all movement to stop.
6.
Allow machine components to cool.
Installing the Kit
Installing the Sensor Module
1.
Secure the sensor module to the mounting
bracket using 2 bolts, 2 washers, and 2 nuts
(Figure
1).
Qty.
–
Prepare the machine.
1
2
2
2
Install the kit.
1
1
1
1
Install the decal.
1
–
Calibrate the sensor.
–
Update the machine software.
1. Nut
2. Mounting bracket
3. Sensor module
2.
Torque the fasteners to 4.2 N∙m (37 in-lb).
2
Use
Figure 1
4. Washer
5. Bolt
g317371
Advertisement
