Advertisement
Available languages
Available languages
GALLUNOPTIMAL
THANK YOU FOR PURCHASING A GALLUNOPTIMAL SOLDERING IRON. PLEASE READ THE MANUAL BEFORE OPERATING AND
KEEP IT IN A SAFE PLACE EASILY ACCESSIBLE TO ALL USERS.
Before leaving the factory, the soldering iron is subjected to a test. This results in the soldering tip being covered with solder
and may be slightly discolored. This does not represent a defect.
Failure to observe the following instructions may result in serious injury or death to the user.
When the unit is switched on, the soldering tip automatically heats up to the last set temperature. There is a risk
of burns on the metallic surfaces!
The device is designed for soldering soft solder at different temperatures. Any other use is not permitted.
Do not touch the metallic parts of the soldering iron during operation and for at least 20 minutes after switching off, CAUTION!
Danger of burns!
Do not use the device in the vicinity of flammable substances and components.
Use a heat-resistant work surface and keep your workplace clean.
Solders, fluxes and heated materials can develop harmful properties and should be exhausted in a controlled manner. Do not
inhale these toxic fumes or gases and provide adequate ventilation.
The use for operation may only take place in dry indoor areas, protect the device from liquids and moisture, also by possibly wet
hands. Otherwise, short circuits and electric shocks could be triggered.
Inform other persons in the working area that the temperature can be very high during operation. Switch off the device as soon
as the work is finished to avoid danger.
Do not leave the device unattended while it is switched on in operation.
After switching off, wait until the heated parts have reached room temperature if you want to touch or change parts on them.
Features
Technical data
Commissioning:
Temperature setting:
EU Declaration of Conformity according to Low Voltage Directive 2014/35/EU (Nr. 01-20)
The manufacturer/ distributor Bräunlich GmbH. Am Heideberg 26, 06886 Lutherstadt Wittenberg
hereby declares that the following product
Product name: GALLUNOPTIMAL soldering iron
Trade name: GALLUNOPTIMAL GOHLK300
Model designation: GOHLK300
complies with the provisions of the Low Voltage Directive
2014/35/EU - including its amendments in force at the
time of declaration.
The following harmonized standards have been applied:
City:
Lutherstadt Wittenberg
Date:
10 July 2023
+49 (0) 3491/6181-0
Tel.
info@loet-shop.de
e-mail:
www.loet-shop.de
Soldering iron
Temperature control / iron coated and pre-tinned permanent soldering tip /Ceramic heating
element / LED operating display
Mains voltage
Power
240VAC
300W
1.
Bend the inner part of the support upwards.
2.
Place the soldering iron on the tray.
3.
Plug the power cord into the socket.
4.
Heat up, the LED lights up continuously.
The temperature can be changed via the power.
200°C corresponds to approx. 100Watt
600°C corresponds to approx. 300Watt
If fast heating is required, 600°C must be set.
WARNING
Temp. range
200-600°C
"DIRECTIVE OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL on
the harmonization of the laws of the Member States relating to
electromagnetic compatibility".
The following national or international standards (or parts/clauses
thereof) and specifications have been applied:
EN 55014-1:2017
EN 55014-2:2015
EN IEC 61000-3-2:2019
EN 61000-3-3:2013+A1
_______________________________
(Signature)
Tobias Bräunlich, CEO
GOHLK300
Heating element
Heating indicator
Keramik
Bräunlich GmbH
Am Heideberg 26
D-06886 Lutherstadt Wittenberg
LED
Advertisement
