Zennio INZennio Z38 Technical Documentation

INZennio Z38 – Touch Display with Ambient Thermostat, IR receiver and Binary Inputs.
ZN1VI‐TP38
CHARACTERISTICS:
KNX 3.8" back-lighted monochrome Touch Panel
Room Thermostat
12 configurable direct control functions
6 additional screens with up to 6 functions each:
Scenes
o
Alarms
o
Schedule programming
o
Climate Management
o
Display parameters
o
IR receiver
4 binary inputs for potential free push buttons
Only bus connection is required
No Power Supply different from the BUS required
KNX BCU included
Complete Data Saving in case of Power Failure
CE directives OK
CONCEPT
Device Type
o
o
EIB/KNX
o o
Supply
o
o
External Power Supply
o
Operating Temperature
o
Storage Temperature
o
Ambient humidity (relative)
o
Storage humidity (relative)
o
Complementary characteristics
o
Safety class
o
Operation type
o
Device action type
o
Electrical solicitations period
o
Nº of Automatic cycles per auto action
o
Type of Protection
o
Assembly
o
Minimum clearances
o
Response to BUS voltage failure
o
Response to BUS failure recovery
o
Function indicator
o
Accessories
o
PCB CTi index
o
Enclosure
o
Weight
o
© Zennio Avance y Tecnología S.L.
Technical Documentation
Voltage
Voltage range
Consumption
Connection Type
Edition 7
DESCRIPTION
Electric Operation Control Device
29V DC SELV
20...31V DC
480mW (two pay loads)
Typical BUS connector TP1, 0,50 mm² section
No
0º C to +45º C
-20º C to +60º C
30 to 85% RH (no condensation)
30 to 85% RH (no condensation)
Class B
II
Continuous operation
Type 1
Long
100.000
IP20. Clean environment
Independent Control Assembly device
Vertical position, with the IR receiver and the
temperature sensor to the bottom. See "installation
figure"
Keep away from heat and cold air flows to get better
temperature sensor measures
Complete data saving
Before Failure Data recovery
Several on Display as programmed
IR Remote Control (optional)
175 V
PC-ABS, flammability category class D
250 gr.
Further information
INZennio Z38
Technical Documentation
www.zennio.com
Page 1 de 4