Table of Contents
Advertisement
CT-W801R, CT-W851R, CT-W701R
e In the case of tape end, the CD player searches for the head of
the song which had been interrupted first, and then sets into the
PLAY/PAUSE mode. (PLAY BACK PAUSE). Although the end
processing is performed according to the reverse mode, when the
tape becomes reversed, the CD player will not played but made
to wait at PLAY/PAUSE for 10 seconds after REC has been set
to let the leader section to pass by.
e If side II is in the FF or REW mode when relaying from side I
to side II, the relay will not be performed.
¢ When the relay mode is on, relay from side I to II is performed
when the CD player performs the first disc changing. (When side
II can be relayed)
e When more than one minute has passed after both sides have
stopped, the CD player which has been set into the PLAY BACK
PAUSE mode will stop (fail-safe). If a tape is re-inserted during
this time and the CD
SYNCHRO
key is pressed, the CD
SYNCHRO COPY can be continued.
¢ In the case of disc end (when disc is not changed), the deck is
set into REC/PAUSE and then stops after 1 minute (fail-safe).
However,
the CD SYNCHRO
COPY
can be continued once
again by pressing the PLAY key of the CD player during this
time.
* For disc changes during CD SYNCHRO COPY with a multi or
twin CD player, the deck sets into REC/PAUSE during disc
changing. The CD SYNCHRO COPY continues once again after
the changing completes and the CD player becomes PLAY.
e The deck side has been adjusted so that the blank time
created on the tape during tape end and disc change is 4 to S
seconds,
3. The receiving and transmission format of the control signal
between the deck and CD player during the CD SYNCHRO
mode is as follows.
¢ When the deck commands the CD player
PLAY
"L"
EDGE
PLAY
BACK
PAUSE
"H"
EDGE
¢ When the CD player commands the deck
REC/"PAUSE
"H"
EDGE
REC
(PAUSE
released)
"L"
EDGE
52
¢ When the deck informs the CD player of the current mode
¢ When the CD player informs the deck of the current mode
CD Player Mode
FROM
CD
PLAY, SEARCH
"L"
STATE
PLAY
BACK
PAUSE
"L"
STATE
Other than above
"H"
STATE
Note)The ''H" and ''L" in the table indicate the ''active" after
the outputs of the two CPU ports have been inverted via the
buffer (Active received by the two CPU input ports).
Advertisement
Table of Contents
