Salt Indicator - Beko DSFN 6830 Extra Manual

Programming the Delayed
Start
You can delay the start of the selected
program until 9 hours. Delayed start
can not be set after the program starts.
The selected program must not be
started in order to be able to set the
delay time.
Delayed start indicator
(13) will start flashing when the
delayed start button (6) is pressed. You
can set the desired time by pressing
the delayed start button (6). Press the
Start / Pause / Cancel button (2) after
setting the time. The delayed start
indicator sand glass (13) and play
icon (12) will remain lit on the display
during the delayed start countdown
and the delay time indicator (11) will
display the remaining time. Program
will start automatically when the
countdown is over.
You can use the delayed start function
if you are utilizing the economic
electricity tariff.
If you want to change the program or
functions while the delayed start
function is enabled, then pause the
machine by pressing the Start / Pause
/ Cancel button (2). You will see that
the countdown stops. The delayed start
indicator will start flashing. Select the
new program and/or add the functions
as described in Program Selection
and Table of Average Consumption
Values. Resume the delayed start
countdown by pressing the Start /
Pause / Cancel button (2).
If you want to cancel delayed start
countdown while it is in progress, then
press the Start / Pause / Cancel button
(2) for three seconds. Release the
button when
flashing in the display. For a couple of
minutes the machine will fulfill the
necessary operations required for
cancellation. Remaining time indicator
(11) displays "0:00". You may select
sand glass
and operate a new program following
the delayed start countdown
cancellation process.
If you want to select a new delayed
start time while the delayed start
countdown is in progress, then pause
the machine by pressing the Start /
Pause / Cancel button (2). Set the
desired time by pressing the Delayed
Start Button (6). Start the countdown
for the new time by pressing the Start /
Pause / Cancel button (2) again.

Salt Indicator

Please check the salt indicator (9) on
the display to see whether there is
enough softening salt in your machine
or not. You need to refill the powder
dispenser whenever the salt warning
indicator light lights.
WARNING:
If the water hardness level is stored
as (r1), salt indicator will never come
on even if the salt container is empty.
(Adjusting the water hardness level is
explained in Water Softening System
section.)
26 GB
symbols (12) start