Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for METRACLARK ICE BABY IM Series
-
Page 3: Table Of Contents
CONTENT Introduction Safety Tips Structure Accessory Control Panel Installation Operation Cleaning and Maintenance Technical Parameters Troubleshooting Circuit Diagram... -
Page 4: Introduction
IM Series Automatic Ice Maker Introduction Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance. Safety Tips • Position on a flat, stable surface. • A service agent/qualified technician should carry out installation and any repairs if required. -
Page 5: Structure
IM Series Automatic Ice Maker Structure 1 Switch 2 Display Panel 3 Slide Door 4 Shelf 5 Water Cabinet 6 Ice Full Sensor 7 Ice Storage Cabinet 8 Power Cord 9 Water Inlet Connector 10 Screw for Drainage 11 Water Outlet Connector 12 Foot Accessory φ12... -
Page 6: Control Panel
IM Series Automatic Ice Maker Control Panel POWER SWITCH FAULT WATER FULL Installation 1.Remove the appliance from the packaging and remove the protective film from all surfaces. 2.Remove the Ice Spoon, Water Inlet Tube, Water Drainage Pipe and Sealing Washers from the ice storage cabinet. 3. -
Page 7: Cleaning And Maintenance
IM Series Automatic Ice Maker discard the first two batches of ice. This cleans the internal systems of the ice maker. 1. Connect the device to a grounded single power socket. 2. Press the Power switch to the ON position [I]. The Switch light illuminates and the appliance start to work. -
Page 8: Technical Parameters
IM Series Automatic Ice Maker Technical Parameters (tested under the conditions of ambient temperature 1 5℃ and water temperature 10℃ ) Ice making Power Model capacity Input Ice Storage Dimensions (mm) (kg/24h) (kg) IM-20 330×503×607 IM-25 398×542×682 398×512×786 IM-25A IM-50 548×610×823 IM-50A 500×610×893... - Page 9 IM Series Automatic Ice Maker Problem Possible Cause Suggested Solution ·Device dose not work ·Power supply is interrupted ·Check the power supply · Power supply voltage is not ·Cut off the power supply (Without any lights come on) correct ·Cut off the power supply ·...
-
Page 10: Circuit Diagram
IM Series Automatic Ice Maker Circuit Diagram IM-25A IM-50 IM-50B IM-80A IM-20 IM-25 Circuit Diagram×2 IM-100 IM-120 · 7·...
Need help?
Do you have a question about the ICE BABY IM Series and is the answer not in the manual?
Questions and answers