Advertisement
CONNECTING
AC ADAPTOR
BOSS PSA-series
TO AC Adaptor Jack
Power is switched on
while
a
plug
is put
into Input Jack.
@Connect
only
to
this
jack
to obtain monaural sound.
@Mixed
sound
of the delay
and direct in Normal made.
@ Only the delay sound in Ste-
reo mode.
Digital Delay
10:2
In case requiring only the delay sound (for connecting
to Echo Send/Return
of a mixer), use only the Direct
Output Jack.
Only the direct sound
AMPLIFIER
(Unplug this unit when it is not to be used, Be sure to take off connecting plug from Input jack.)
DESCRIPTION
CHECK INDICATOR
The Check
Indicator enables you to confirm if
the Effect is ON or OFF, and as well to check
the battery. If the Check Indicator lights up by
pressing the Pedal Switch down, Delay Effect is
on, and if goes out, Delay Effect is OFF (Normal).
*Hold
Effect works as long as the pedal is held
down.
DELAY TIME
This knob allows to finely adjust the delay time
set with the Mode Selector Switch by from ''X
0.25"
to
"X1"
continueously.
Turning
this
knob
clockwise
increases
the delay
time, and
counterclockwise decreases it.
LEAD GUITAR
BASS GUITAR
KEYBOARD
—_—__________—e AC ADAPTOR
JACK
The AC-adaptor (BOSS PSA-120, 220 or 240)
should be connected to this jack.
*BOSS
ACA-series must not be connected, use
specifically PSA-series.
*The battery should be replaced, when the indi-
cator lights but only dimly or does not light
Bama
EFFECT LEVEL
This knob controls the output level of the delay
sound.
Turing
this
knob
clockwise
increases
the level
of the delay sound. With this knob
turned fully counterclockwise, the output level
of the delay sound
is equivalent to that of the
direct
sound.
Also
when
this
knob
is turned
fully counterclockwise
in Normal
mode,
only
the direct sound is obtained, while no sound is
heard from the Main Output in Stereo mode.
MAIN OUTPUT JACK
Monaural signal (the mixed signal of the direct
INPUT JACK
This jack should
be connected
to an electric
guitar or other musical instrument.
*The
unit
is powered
on
by
plugging
to the
Input Jack and is powered OFF
by unplugging.
*By muting circuit system no Effect works for
about 5 seconds after the unit is powered on.
DIRECT OUTPUT JACK
When
a plug is connected
to this jack, direct
sound
is output from this jack, and delay sound
is output from the Main Output Jack.
@ MODE SELECTOR
SWITCH
The Mode Selector Switch has 4 modes, S,M, L,
and Hold. The delay time changes from 12.5ms
to 800ms continueously
by using this selector
and the Delay Time knob,
In Hold made, the
Delay Time
knob controls the repetition time
of the hold sound from 200ms to 800ms. The
Pedal Switch works as long as the pedal is held
down.
and delay sounds) is output from this jack. (If
the plug is not connected to the Direct Output
THUMB SCREW
When
the battery
needs
replacing,
loosen
this
screw to open the pedal and replace the battery
with a new one.
*The screw should not be pulled out, but if needs
removing for some reason, do not lose it.
—ePEDAL SWITCH
The Pedal Switch works as Delay Effect ON/OFF
or Hold ON/OFF switch.
*Due
to
FET-switching
system,
audible
click
noise problem is solved, thus the DD-2 is most
suitable for studio recording.
Advertisement
