Care And Maintenance; Technical Data - Tarrington House VBQ-MGB21208 Manual

OPERATING INSTRUCTIONS
7. COOK WITH MANUALLY SET DESIRED TEMPERATURE
Press MODE to select TEMPERATURE mode, then press
and hold the + or - button to manually set the temperature
in the LCD screen (see Fig.7). Then begin cooking. The
thermometer alert will beep and the LCD will flash when the
meat has reached the target temperature.
Press any button to silence the alert.
8. PROBE INSERTION
Insert probe tip into the center of the thickest part of the
meat, taking care not to pierce through it. Do not expose
any part of the probe to open flames (see Fig.8).
8
9. COUNT-UP/ COUNT-DOWN TIMER
Press MODE to select TIMER.
To set a count-down time, press H/M (Hours/ Minutes)
(see Fig.9).

CARE AND MAINTENANCE

Unplug the meat probe from the thermometer. Hand wash the meat probe
ONLY using mild soap and hot water. Rinse thoroughly. Dry completely.
WARNING: DO NOT MIX old and new batteries. Do NOT MIX alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
DO NOT dispose of batteries in fire. Batteries may explode or leak. Please dispose of batteries properly. Remove the batteries
when not in use for an extended period of time. Batteries could leak causing corrosion
PROBLEM
Current temperature dose
not appear on LCD upon
powering ON.
Meat over/under cooked.

TECHNICAL DATA

Frequency band:
Maximum radio-frequency power:
7
/
HM /
POSSIBLE CAUSE
1. Probe is not connected properly
2. Do not turn on the base.
3. The distance from transmitter to
wireless thermometer is too far.
Probe not centred in the thickest part
of meat.
433.92 MHz
10mW
Press + or - to increase or decrease the displayed time. Press
and hold to increase or decrease the time setting quickly. To
begin the count-down time, press when you start cooking.
To set a count-up time, without setting a time, press
start from zero.
To pause the timer during a count-down or count-up, press
. To reset to zero, press
/ for 2 seconds.
When the count-up or count-down is finished, the thermometer
will beep and the LCD will flash.Press any key to silence the
alert.
NOTE: The timer will count up to / down from 23:59: 59. Press
MODE to switch to the temperature settings.
10. PLACEMENT
Hang the transmitter base with magnet and take the
thermometer by your side (Fig.10b ) .
10b
CORRECTIVE ACTION
1. Check to make sure the probe connector plug is
properly inserted into the probe port. If problem
persists, check batteries.
2. Check to make sure the base is turned on and LED
light is flashing.
3. Operating the wireless thermometer within 50
meters away from the transmitter.
For best results, make certain the probe is positioned
properly.
/ to pause, then press and hold
9
/
HM /
220809
Art. Nr.: VBQ-MGB21208
QA20-0000003463
/ to
/