Attached Fittings - Baxi IQWH20 Installation Manual

3. ATTACHED FITTINGS

Please check whether the following fittings are of full scope. If there are some spare fittings , please restore them carefully.
NAME
1. Screw ST3.9x25 for installation board
2. Plastic expanded tube
3. Wrapping tape
4.Drain pipe
5. Wall conduit cover
6. Remote controller
(including operation manual)
7. Frame
8. Mounting screw(ST2.9
9. Alkaline dry batteries (AM4)
10. Owner's manual
11. Installation manual
12. seel gasket
1
14. insulation
Cautions on remote controller installation:
Never throw or beat the controller.
Before installation, operate the remote controller to determine its location in a
reception range.
Keep the remote controller at least 1m apart from the nearest TV set or stereo
equipment. (it is necessary to prevent image disturbances or noise interferences.)
Do not install the remote controller in a place exposed to direct sunlight or close to a
heating source, such as a stove.
Note that the positive and negative poles are right positions when loading batteries.
This manual is subject to changes due to technological improvement without further
notices.
SHAPE
10-C-H)
QUANTITY FUNCTION
8 Secure the installation board
8
1
1
1
1
Hold the remote controller
1
2 Insulation Holder for remote controller
2
1
This manual
1
4 For connect water pipe
The indoor unit which at the
terminal of communication system
1
should connect a impedance
between port X and port Y.
Prevent the walls from getting damp
1
SET TEMPERATURE(°C)
AUTO FAN
COOL HIGH
DRY MED
HEAT LOW
TEMP
FAN
ON/OFF
SPEED
MODE
ECONOMIC
SWING TIMER
RUNNING
VENT CANCEL
RESET LOCK
Remote
controller
Mounting screw B
ST2.9x10-C-H
Remote controller
holder
Fig.3-1
installation manual
3