Advertisement
Advertisement
Table of Contents
Related Manuals for K2 Yeti Clamp 2.0
Summary of Contents for K2 Yeti Clamp 2.0
- Page 1 CONNECTING STRENGTH K2 Yeti Clamp 2.0 QUICK GUIDE k2-systems.com...
- Page 2 (6 - 35 Nm) Torque 11.8 ft-lbs Important note The K2 Yeti Clamp 2.0 must be installed in an array. It cannot be installed on a single module that is not connected to the array by a mid clamp. Frame Compatibility: Flange Thickness = 1.6 - 2.5 mm...
- Page 3 The Paper Strap acts as an aid to facilitate installation. With the Paper Strap unrolled, slide the K2 Yeti Clamp 2.0 into the rail channel with the screw facing out. Slide the K2 Yeti Clamp 2.0 onto the rail leaving enough room to place the module.
- Page 4 Use a standard ratchet or drill with a 13mm deep box socket and drive in the socket head cap screw and tighten to 12 ft-lbs. NOTE: While tightening the K2 Yeti Clamp 2.0 with the socket pull the Paper Strap towards you. Do not use an impact drill.
- Page 5 The inside edge of the module frame flange must be fully engaged with the K2 Yeti Clamp 2.0 as shown in the image. Install end cap to create a flush, clean look! Quick Guide K2 Yeti Clamp 2.0 US V1 | 0623 · Subject to change · Product illustrations are exemplary and may differ from the original. original...
Need help?
Do you have a question about the Yeti Clamp 2.0 and is the answer not in the manual?
Questions and answers