OLG Quickstand Handset Directions For Use

Quickstand Handset
The whole handset surface is a button panel. If there is no activity within 30 seconds, the screen is locked and 1/2/3/4/S keys
are locked accordingly, you should press the Up or Down key first, it can be used when the display screen lights up.

DISPLAY SCREEN

Displays the height value of the desk.
UP & DOWN KEYS
Please keep pressing Up/Down key to adjust desk height until you get to the desired height.

MEMORY KEYS 1/2/3/4

After setting memory keys, the desk can lift automatically to memory height.

HOW TO SET MEMORY MODE

Click the "S" key when you have adjusted to a specific position. The display screen displays "S-" and "-" flashes. At this time,
press "1-4" button to store that position to the desired number. The memory height is successfully saved. Then lightly press
1/2/3/4, the desk moves to the set memory height automatically.

SET KEY(S)

Press the "S" key when customised parameters need to be set.

INITIALIZATION

1. When "RST" is on the display screen, press the " " button until the desk frame reaches its lowest point.
After hearing the "di" sound and desk frame rebounds, initialization is completed.
(P.S. The button cannot be released during this operation, otherwise the initialization will fail).
2. Forced Initialization: Press the " " button until the desk frame reaches its lowest point, then release the button
and press it again for about 5 seconds until hear the "di" sound and desk frame rebounds, and the initialization
is completed.
3. Restore the Factory Settings: When a new controller is changed or the parameters need to be restored to the
factory settings, press the " " and " " buttons simultaneously, you will hear the first "di" sound after about 5
seconds and second "di" sound after 10 seconds. When the display screen shows "RST", please refer to 1.
above for further directions.

SAFETY FUNCTION

When the desktop is rising or lowering and it encounters resistance, the desk will rebound automatically.

HANDSET SHOWS ERROR CODE AND SOLUTION

Error Code
E1, E6, E7
E2
E4
E5
E8
E11, E21
E12, E22
E14-E17, E24-E27
E18, E28
HOT
Directions for Use
Display Up & Down
Screen Keys
Fault Cause
Power Fault
Asynchronous Height Over 1cm
Handset Fault
Anticollision Alert
Desktop Sloping
Motor Defect
Controller Fault
Motor Fault
Overloading
Overtime Operation
Memory Keys Set Key
Solution
Change Power
Implement the Initialization Operation 1
Unplug and Replug the Cable of Handset
Rebound Reminder, Normal Condition
Check the Desktop
Inspect the Motor Wire
Exchange the Controller
Change Motor
Reduce the Loading
Automatic Recovery After
Stop Using for 20 Minutes