Deep Fitted Electric Blanket
L473/L474/L475
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
•
Prior to use, warm-up for 10-15 minutes on level 3 setting whilst the blanket is fully covered under a
duvet / comforter/ quilt etc. This is to retain generated heat.
Connecting the Controller
To remove the controller, lift the locking tab up with your finger and pull the plug out directly.
Do not pull the controller cable and Do Not try and pull the controller plug out without lifting the locking tab
as you will damage the socket.
NOTE: On initial use, it is recommended that the blanket be set on "3" for 2 hours before sleeping on the
bed. This will assist in drying out any moisture which has accumulated in the mattress.
You may notice an odour when using the blanket for the first time, due to the insulation material, this is
harmless and will dissipate quickly.
IMPORTANT: Ensure the controls are in a position that will not allow dripping water to fall onto any part of
the controller.
The Enterprise
Department
v02: 03/07/23
Dimensions
Single L473 W91 x L190cm
Double L474: W137 x L190cm
King L475: W152 x L200cm
Material: 100% Polyester, 300g/m2 Sherpa Fleece
+ 100% Polyester 400g/m2
Cable 1.5m. 220V-240V, 50Hz
Single: 60W, Double & King 2x60W
UK Head Office, 11 Bridge Street, Bishop's Stortford, CM23 2JU
Tel: 0330 331 0300
www.coopersofstortford.co.uk
EU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France
Tel: (+44) 1279 701269
Fax: 01279 756595
Need help?
Do you have a question about the L473 and is the answer not in the manual?
Questions and answers