Mitsubishi Electric MSH-07RV Operating And Programming Manual page 7

With the "@ (f FEEL...)" auto operation mode,
the optimum room condition can be set automati-
cally with a one-touch operation.
ONOFF 109, Wage
|
E Press th
o To start operation:
E Press th buiton.
When the *£3 (I FEEL...) mode is selected, the air
conditioner is automatically controlled at the optimum
temperature.
e To stop operation:
[d
button.
9 [f you feel slightly warm:
xA
Press the (1) button to lower the tempera-
ture.
One press lowers the temperature by about 1°C.
9 if you feel slightly cool:
Press the à button to raise the tempera-
ture.
One press raises the temperature by about 1°C.
Description of "1 FEEL.. mode
Details of operation
According to the room temperature when the operation starts, E
the operation mode is automatically selected COOL, DRY or 3
HEAT. However, when operation is started again within 2 hours
after it is stopped, the same operation mode before the opera-
tion is stopped is selected. The operation mode selected first is
not changed even if the room temperature changes. if the op-
eration mode does not match the room condition, select the ap-
propriate operation mode by pressing the M995 button.
Room temperature:
About 25°C or higher
— COOL
About 25°C - 23°C
— DRY
About 23°C or lower
Details of auto operation z
Room temperature M Target temperature
when started Operation mode (initial state)
About 25*C or higher COOL About 24°C
About 25°C - 23°C DRY =
About 23°C or lower HEAT About 26°C
NOTE
COOL: When the room temperature is 2°C higher than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until the
room temperature drops to within 2°C of the set temperature and then operate.
HEAT: When the room temperature is 2°C lower than the set temperature, the set temperature may not be changed
since the air conditioner is operating to reach the target (set) temperature. In this case, please wait until the
room temperature rises to within 2°C of set temperature and then operate.
When"&5 (IFEEL...)" is not selected, press the
#2 button until it is set.
Each time the button is pressed, the operation mode is
changed in sequence: £5 (i FEEL...) Zt (COOL) —> ô (DRY)
— € (HEAT)
Details of display on the indoor unit
The operation indicator at the right side of the indoor unit indi-
a =
cates the operation state. ===
MSH-07/09/12RV MSH-18/24RV
Lighting = Lighting
«n Operation Indicator]
Blinking 0 É — Blinking*
Not fighting di^. Na Roniin
Operation indicator lamp
The following indication does not depend on the shape of lamp.
Difference between target
Operation state
This shows that the air conditioner is operating to reach the
target temperature. Please wait until the target temperature
is obtained.
About 2 *C or more
This shows that the room temperature is approaching the
target temperature.
About 2 *C or less
(In case of outdoor unit MXZ series only)
Please refer to INFORMATION FOR MULTI SYSTEM AIR
CONDITIONER (page 8).*
* Except MSH-24RV