Diamond D3 Product Owners Manual page 10

Input Mode
Switches between input modes.
2 CH BASS - Input from only one set of RCA's in mono mode. Rear channels use front
inputs for a mono signal. Only for use when the amplifier is used for subwoofers.
2 CH - Input from only one set of RCA's in stereo mode, no fade. Rear channels use front
inputs for a stereo signal.
4 CH - Input from two sets on RCA's for true 4 channel stereo mode. Rear channels use
rear inputs for a stereo signal.
D3 600.1
Remote Gain
The D3 mono block amplifier comes with a remote gain output. The remote gain module
(included) plugs into this output to allow for gain control away from the amplifier. When
you plug this module in, it replaces the gain from where it is set on the amplifier. Max
(all the way clockwise) on the module is set to whatever the gain on the amp is set to.
Note: Diamond D5 & D6 remote gains do not work with the D3 600.1.
INPUT
The RCA cables from your source unit should be inserted here.
I
9
I
©2005 Diamond Audio Technology. All Rights Reserved