Page 6
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual 2.2.2 2.2.2 Load inertia ratio tuning The preset turns number of the machine tuning stroke is 2.
Page 7
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual After confirming the obstacle-free, repeat it 3 times to see if the load inertia ratio is adjusted correctly 2.2.2.2 Load inertia ratio tuning...
Page 8
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual c. Set the the stroke limit d.
Page 9
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual e. Enter the results, before tuning start, Syntec Analytics will check if the tuning speed can reach more than 80% of rated speed, that will be more accuracy.
Page 10
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual Turn off all advanced functions first.
Page 12
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual 2.2.4 2.2.4 Speed loop automatic gain tuning Set the first stroke limit and the second stroke limit, as A shown in the figure below...
Page 14
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual 2.2.5 2.2.5 Position gain tuning When the speed loop gain of each axis has been tuned, then execute the position gain tuning.
Page 20
自動化產品/Automation Products – 70CA/70CB/710CA Laser Cutting Machine Assembly Manual • Set the DIP switch of a single axis drive to a number different from...
Page 35
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual B. After completing the settings according to the figure below, click "Gate" and "Laser" to perform the laser test.
Page 37
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual Stainless steel materials focus: adjust different cutting heights by cutting straight lines, and then adjust the material focal length corresponding to the best line (0.8mm stainless steel, cutting height 1mm)
Page 39
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual Potentially affected situations, such as: The blowing air pressure will affect the machining, so the gap height shall be adjusted accordingly;...
Page 40
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual The pierce height, pierce time, frequency, duty cycle, focal length and other values is set in the pierce process parameter.
Page 43
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual To use the auto-focus function, turn on the auto-focus function (operation path: home screen → F5 peripheral test) and set its relevant speed after setting all parameters as described above.
Page 74
自動化產品/Automation Products – 70CA/70CB/710CA Laser Cutting Machine Assembly Manual R17533 Record the execution state before the mid- program breakpoint.
Page 75
– 70CA/70CB/710CA Laser Cutting Machine Assembly Manual 13: The shift of marking is...
Page 86
自動化產品/Automation Products – 70CA/70CB/710CA Laser Cutting Machine Assembly Manual R17743 confirmed that It's already removed and available again at AUTO-5367 former definition...
Page 103
自動化產品/Automation Products – 70CA/70CB/710CA Laser Cutting Machine Assembly Manual R223 confirmed that It's already removed and available again at AUTO-5367 former definition...
Need help?
Do you have a question about the 70CA and is the answer not in the manual?
Questions and answers