Onkyo TX-902 Instruction Manual page 9

Remote control transmitter (7X-962 only)
® The tuner amplifiers are provided with the following remote
control transmitters:
USA and Canadian models................ ee eae RC-183S
other area models....... UN ge a RC-184S
Power Button (POWER)
Phono Operation Button (PLAY/REJECT) ——
(RC-183S only)
This button is used to operate the turntable.
The phono operation button can be used only
"when the PHONO input selector button has
been pressed. Each time the phono operation
button is pressed, the remote control transmitter
_ alternately emits the play or reject command.
CD Operation Buttons (CD) ~~
These buttons are used to operate an ONKYO
CD player with the Ff mark. |
® :Press this button to play the CD |
player.
ge : Press this button to pause the CD
play back. To resume disc play,
press the PLAY button.
—______________ Input Selector Buttons (TAPE-1,
TUNER, PHONO, CD, TAPE-2) [9]
% When the TUNER button is pressed, the
station which was received previously is
recalled. Selection of AM or FM should be
done on the main unit.
y— Tape Operation Buttons
(DECK-A, DECK-B)
These buttons control Onkyo double cassette
tape decks that can be remote controlled. Use
the DECK-B buttons to control single cassette |
tape decks with the QE mark.
@/sta . When this is pressed, the recording
DISC: Press to use for sequential selection
of discs in the order they were
loaded on the CD changer.
(RC-183S only)
@ :Press this button to stop the CD
player.
é¢ =: Press this button to go back to the
beginning of the current track and
again to skip back to the previous
track.
bey : Press this button to skip to the next
track.
- Audio Muting Button (AUDIO MUTE) and SS teeeeesrsemnemgemm
Indicator
This button temporarily switches off the sound
from the speaker or headphone. Pressing this
button will operate the TX-902 audio muting
circuit. The audio muting indicator "AUDIO
MUTE" will flash. Pressing the button again
or using the POWER button on the remote
control transmitter to turn the power on will
Per ene 2 Saar os SAC Sane we Fete coe
turn off the audio muting.
stand-by mode is entered.
et : The tape plays, moving from right
é to left, or, in the recording stand-by
e mode, recording begins.
: iE : Interrupts all operations.
> : The tape plays, moving from left to
right, or, in the recording stand-by
mode, recording begins.
: Fast forward from right to left.
: Fast forward from left to right.
+i
a Tuner Operation Buttons (TUNER) [11]
CLASS: Class selector button
€@ PRESET ® : Preset memory DOWN/UP
buttons |
Using the remote control transmitter
1. Remove the batteries if the remote control transmitter is not going
to be used for a long time.
2. The batteries of the remote control transmitter must be replaced
periodically.
This unit uses infrared rays. Therefore, commands may not be
received properly if the front panel of this unit is exposed to
bright light. To prevent this from occurring, place this unit so
that it is not directly exposed to bright light.
_4. If this unit is placed inside an audio rack behind a glass door,
the door should not have colored glass or have any decorations
on it, since this could shorten the range or prevent commands
from being received.
5. Use of other infrared remote control devices in the same room
may Cause interference.
6. The transmitter operates up to a distance of about five meters
(16 feet). The transmitting window must always be pointed at
the reception window when a command is sent to the TX-902.
a)
Remote Sensor Wa,
approx. 5m
(16 feet)
Remote contro! transmitter