Advertisement
Quick Links
FITTING INSTRUCTION
VVA, VVN
V1.0 (15.1.2013)
1 (2)
By help of this document you can install VVA and VVN water leakage sensors properly.
VVA 1
Place the sensor on the floor as shown in the
picture. Make sure that between the floor
and the lower surface of the sensor remains
about 15 mm gap.
VVA 2
Place the sensor on the floor as shown in the
picture. Make sure that between the floor
and the lower surface of the sensor remains
about 3 mm gap.
VVA 3
Place the sensor on the floor (or correspond-
ing surface) as shown in the picture. Use
glue to attach the sensor. Make sure the
sensing surface is placed upward.
Produal Oy
Keltakalliontie 18, 48770 Kotka FINLAND
Tel: +358-5-230 9200 / Fax: +358-5-230 9210
info@produal.fi
www.produal.com
Advertisement
Summary of Contents for Produal VVA
- Page 1 VVA, VVN V1.0 (15.1.2013) 1 (2) By help of this document you can install VVA and VVN water leakage sensors properly. VVA 1 Place the sensor on the floor as shown in the picture. Make sure that between the floor and the lower surface of the sensor remains about 15 mm gap.
- Page 2 FITTING INSTRUCTION VVA, VVN 2 (2) VVN 1 & VVN 2 Attach the sensor on the side of the pipe as shown in the picture. Use cable tie or tape. Do not attach the sensor around the pipe, because water condenses on the bottom surface of the pipe.