OPERATION To use the XLT-100, power device on, place headphones over ears and press metal tip to the utility. Before the tip makes contact, mute the XLT-100 using the button; the tip making contact can produce a loud sudden bump sound. The XLT-100 amplifies vibrations in the object for listening and displays the average sound/vibration level as a number between 0 and 99.
4000 Hz. The boost filters and-hold for approximately emphasize frequencies around 2 seconds, then release. When the center frequency. muted, the XLT-100 will power off The cut filters will de-emphasize automatically after 5 minutes. frequencies around the center frequency. Alternatively, the user MODES...
Page 4
OFF or MUTE immediately after out. If this happens, gently tap each sampling. the bottom of the XLT-100 on For safety reasons, do not a flat surface, and batteries will use this device near traffic dislodge.
Page 5
TRANSDUCER TIP MODE MUTE LEFT/RIGHT CONTROL POWER BACK LIGHT DISPLAY...
Page 6
ICES-003 Class B Notice This Class B digital device complies with Canadian ICES-003(B)/NMB-3(B). EU Declaration of Conformity Hereby, Fisher Research Labs ®, declares that the XLT-100 Compact Acoustic Leak Detector complies with the EMC standards under Directive 2014/30/EU. EN 61000-6-1...
2-YEAR LIMITED WARRANTY This Fisher instrument has been rigorously tested before shipment. Fisher Research Laboratory (FRL) warrants this instrument to be free of manufacturing defects for a period of 2 years after the original date of consumer purchase. This warranty gives you specific legal rights and you may also have other rights that may vary from state to state.
Page 8
85 years, the Fisher logo has been a mark of excellence. S E R V I C E Should you have any questions or problems, contact: FISHER RESEARCH LABS, INC. 1120 Alza Drive, El Paso, Texas 79907 Tel 1-800-685-5050 Fax 915-225-0336 www.fisherlab.com email: info@fisherlab.com...
Need help?
Do you have a question about the XLT-100 and is the answer not in the manual?
Questions and answers