Jiecang JCD25SLEU-SEH Operation Manual

Wand Motor
Motor Head Button(H)
Up Stop
Prg
Caution
1.This product is for indoor use only, do not use outdoor or in humid environments.
2.This motor has built-in rechargeable Li-ion battery pack with integrated charge
management. Max input voltage: 5V/2A.
3.Please charge it before using for the first time, make sure it is fully charged before first
use. During charging, the blue LED will flicker 3 times every 8 seconds.
After fully charged, the blue LED will be always on.
4.When the battery voltage is low, LED will flicker 8 times to give a low-voltage alarm when
motor starts.
5.The motor will jog in operation, please do not proceed to the next step until it complete.
6.During operation, the effective interval of the transmitter button operation is 10 seconds.
If there is no effective transmitter operation for more than 10 seconds, it will automatically
exit the current mode.
7. Please do not use motor when charging.
8.Upper&Lower limits cannot be set at the same position, limits saved even power off.
9.The motor runs constantly for at 6 mins max without any other operation.
Down
Type-C USB charging port
5V/2A Type-C USB Charging
3
Sleep Mode,
Wand Control Inactive
Reset
a.Direction Reverse
Prg
b.Upper&Lower Limits Setting
H
Hold H button or Prg for 6s,
LED flickers twice to show
the motor is in sleep mode
and wand control is inactive;
hold H button or Prg for 2s,
it will exit from sleep mode
and wand control is active
again
constant-touch