Page 1
Side panels (2) Roof Lamps (3) Roof vent section Washer screws (28) Ends (2) The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ® , TrainMaster ® , Odyssey ®...
Page 2
Assembling the Covered Bridge our Covered Bridge is easy to assemble using a small Phillips-head screwdriver. Feed the wires through the structure as described in the following steps. Refer to Figure 1. 1. Secure the ends to the roof using four washer screws (two at each end). 2.
Page 3
12-18 volts (AC). You may connect the lamps to a separate accessory transformer or to the track using a Lionel Lockon (available separately, 6-62900) or a FasTrack Accessory Power Wire (available separately, 6-12053). To make the proper connections, the wires must be stripped back 1/8”...
Page 4
Lionel L.L.C. or an authorized Lionel L.L.C. Service Center, together with proof of original purchase will, at the option of Lionel L.L.C., be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a replacement is not available, a refund of the original purchase price will be granted.
Need help?
Do you have a question about the 72-4117-250 and is the answer not in the manual?
Questions and answers