Summary of Contents for YIERYI SGW07
- Page 3 � x AA alkaline batteries Power (not included） �. For outdoor use only. �. Clean the filter regularly and replace it when worn to extend the working life of the timer. �. Remove the batteries during the winter months. Drain and store it indoors to avoid freezing.
- Page 4 �. BATTERY INSTALLATION �) Remove the battery cover from the back of the timer. �) Install � new AA (�.�V) alkaline batteries (not included). �) Reinstall the cover firmly into the timer. �.Close the battery cover tightly to ensure water resistance. �.
-
Page 5: Set Clock
Set Clock. - Page 6 Start Water. to set the start hour and minute.Press " " to confirm.
- Page 7 to set the watering duration hour and minute. Press " " to confirm.
- Page 8 There are � watering frequency setting modes will points to How Often. button to select the watering Press " " to confirm. day of the week. press" " again to cancel the selection, such as "Su". �. Press " " to save and move AUTO. If no day is selected, the schedule will not be executed.
- Page 9 �. Press the " " button to switch from "SU", to "SA". �. When'SA" is flashing, press the “ “button to enter the setting of the day. �. Using the " "button to select the interval watering days of �/�/�/�/�/�/� days. �.
- Page 10 Press the " " button, the " " points to Auto and the program will be running as you set before.
- Page 11 Press the " " button, the " " points to oFF and the screen shows OFF and the battery level. All program are saved but the timer stop working.
- Page 12 �. Press the " " button and press " " button to select watering duration from � min to �� mins. �. Press the " " button to switch the ZONE� and ZONE ZONE�. �. Press " " button , it will start to watering. �.
- Page 13 Please make sure the timer is in Auto Run state. �. Hold and press the " " button �s until the " "appears on the screen. �. Press the " " button to set the duration of the delay from � to � days. �.
- Page 14 Please make sure that the timer is in Auto Run state. Press and hold the " " button for �s until the " " appears on the screen. If you want to cancel the " ", Press the " " button �s again.
-
Page 15: Troubleshooting
TROUBLESHOOTING Problem Possible reasons Possible solutions �. Add a filter and make sure it is �. No filter or not placed placed horizontally in the inlet. �. Make sure the tap is a �/�" tap. horizontally The water inlet leak �.