Recalling A Pattern From Memory; Turning Off The Graphic Equalizer; Contents Of Display - Kenwood KC-991 Instruction Manual

. Graphic equalizer operation
@ Recalling a pattern from memory
Press the M.CALL key to select the memory No.
storing the desired pattern.
Remote Control
EQUALIZER
re) Ee
Wy
EQ.OFF ——* MEMORY1——» MEMORY2
MEMORY5 —— MEMORY4 «—— MEMORY3
Every time the MEMORY key is pressed, the memory Nos.
are switched in the cycle as shown above.
The example shows MEMORY2 recalled.
Lights up
Contents of display
Spectrum analyzer display
Displays the frequency distribution of the source being played to
allow understanding at a glance.
Graphic equalizer display
Shows how each frequency range is compensated. The graphic
equalizer display also appears for about seconds, even while the
unit is in the spectrum analyzer display mode, when one of the fol-
lowing operations is performed.
1. Switching power ON.
2. An operation key associated with an equalizer operation is
pressed.
14° kc-991 (En)
M.CALL key
Turning off the graphic equalizer
Press the M.CALL key
Press and hold until
the equalizer is
turned OFF.
Press the EFFECT key
on the remote
control unit.
Remote Control
EQUALIZER Ey Pe
@ When the key is pressed
again, the equalizer is turned
ON again and the previous
equalizer pattern is recalled.
EQ.OFF ——» MEMORY1——* MEMORY2
MEMORY5 +——~ MEMORY4 «— MEMORY3
Every time the MEMORY key is pressed, the memory Nos.
are switched in the cycle as shown above.
Spectrum analyzer display
18k
Goes out
Graphic equalizer display