Greencut JET220C-7 Instruction Manual page 42

42
ASSEMBLY
HOSE CONNECTION
1. Connect the pressure hose to the outlet of the machine, make sure it
is firmly connected.
GUN CONNECTION
1. Connect the gun lance (fixed brush/turbo lance) to the gun head. Turn the gun lance (fixed brush/turbo
lance) clockwise until it locks into position. Check that the sealing ring is properly seated.
INLET HOSE CONNECTION
1. Connect the water hose to the inlet, make sure it is firmly
connected. Do not turn on the machine at this time.
2. Open the tap, make sure the inlet water pressure is
maintained between 0.01Mpa and 0.3Mpa.
3. Squeeze the trigger until all the air is expelled from the
machine and water flows from the gun. This means that the
pump is full of water.
4. Turn the switch on.
PRODUCT USE
SPRAYER
The spray angle can be adjusted from direct to fan spray by turning the
nozzle.
Exit
High pressure hose
Quick connector (optional)
Water hose