Table of Contents
Advertisement
Astro 250 3200K and 5600K, DMX 512+ RDM LED followspot - User's Manual – 1.0
11.17 ID for REMOTO (ID Rem):
Remoto is a control device which allows to upgrade your Astro with the latest software version or to
load and download stored info. It is available as an optional accessory as follows
A20702072 REMOTO control unit
To change the initial ID press the rotary switch until an arrow appears, then turn to change to the
desired ID number. Press to confirm your selection. It is possible to select an ID number from 0 to
250. If ID number=0 remote control is not active. Factory setting is 000.
Choose
ID Rem
11.18 CALIBRATION (Set Min):
It allows to calibrate the minimum level of the output.
Choose
Set Min
11.19 EXIT HIDDEN MENU (Exit):
It allows to exit from hidden menus.
12.
FOCUSING
This fixture features a variable beam angle from 8° to 23°. The variable beam is modified by adjusting
the front and rear zoom lenses in relation to each other.
The front lens defines the beam spread, the rear lens defines the focus degree of 'softness' or
'hardness' of the beam edge or shutters.
13.
CLEANING AND MAINTENANCE
To ensure maximum performance of the product, a regular maintenance service should be carried
out. Please make sure the product is cold and disconnected from power supply when doing this.
General maintenance
* Clean all reflective parts such as lenses opening the product, if necessary.
* Check the lenses and replace any visibly damaged component.
* Clean air ducts and fans in order to allow a proper ventilation activity on the product.
* Check internal and external wiring and replace any cable which should be damaged by heat or
mechanical agents.
Cleaning of optical components
LEDhouse lenses:
Open the lens compartment door by removing the two M4 cross head screws on the top of the
ledhouse tube and slide the top cover free
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
PRESS TO ACTIVATE
ID Rem
THE MENU
AN ARROW SHOULD
000
APPEAR
PRESS TO ACTIVATE
Set Min
THE MENU
AN ARROW SHOULD
####
APPEAR
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
TURN TO ASSIGN THE
ID NUMBER AND
←
PRESS TO CONFIRM
TURN TO ASSIGN
THE CALIBRATION
VALUE AND PRESS TO
←
CONFIRM
10
info@ldr.it
– web www.ldr.it
ID Rem
###
←
Set Min
####
←
Advertisement
Table of Contents
