Honeywell 1553 User Manual page 6

INITIAL SETUP
UNLOCKING THE CHEST
1. Enter the default passcode (Figure 2.1)
2. Turn the knob to the right to the unlocked position (Figure 2.2).
3. While holding the knob in the unlocked position, lift the lid to open
(Figure 2.3).
Note: The knob will return to the locked position when released.
Figure 2.1
SETTING THE NEW PASSCODE OR RESET PASSCODE
1. Open the lid, remove reset button cover (Figure 2.4) and press the reset button
on the underside of the lock, LED will flash Red to indicate passcode setting
(Figure 2.5).
2. Enter new user 6 digit passcode and press the reset button (Figure 2.6).
3. LED will then flash Green and re-enter the 6 digit passcode.
4. If the passcode both times is a match and 6 digits long, the LED will light up
green for 2 seconds, indicating passcode has been successfully changed.
5. If the passcode both times is not a match or less than 6 digits long, the LED
will light up red for 2 seconds, indicating passcode change is unsuccessful
and revert back to previous set passcode.
Figure 2.4
LOW BATTERY INDICATOR
When entering the passcode, the LED flashes orange to indicate that power is
low and batteries need to be replaced.
INCORRECT LOCKDOWN
1. 3 incorrect entries will lock down the chest for 4 minutes, during this time, all
entries will be invalid.
2. The chest can be opened with the emergency override key during this time,
See page 5.
Figure 2.2
Figure 2.5
4
Figure 2.3
Figure 2.6
*Be sure that the pin receptacles
above the knob area is kept clean.