Advertisement
Thank you for purchasing this Technics product.
For optimum performance and safety, please read
these instructions carefully.
The model number and serial number of this product can be found on the back of the unit; and the serial number either on the
back or the bottom. Please note them in the space provided below and retain this booklet as a permanent record of your purchase
to aid identification in the event of theft.
Model
number
Serial number
Installation
The sound
reproduced by a speaker system is easily influenced by such factors as room acoustics and the system's location
in the room. Before finally deciding where the speakers are to be placed, please read the following information carefully.
*
The bass
sound
will be increased
if the speakers
are placed
on the floor or close to a wall due to the reflection of sound.
It is, therefore,
possible to adjust
the bass
sound
to some
extent
by adjusting the speaker's distance from the wall and /or
floor.
*
Undesirable resonance
of sound reflection will occur if the speakers face a hard wall or window. Curtains or similar materials
can be used to prevent these reflections.
* To prevent possible acoustic feedback, the speaker systems should be kept away from the turntable. This feedback (how-
ling) can result from vibrations from the speakers. The turntable should, therefore, never be placed on the same surface as the
speaker system. A thick piece of felt or similar material can be used under the turntable to reduce howling. Closing the turn-
table's cover also reduces this problem.
Connecting the speaker system
Before connecting the speaker systems to the amplifier, please check the following:
* Be sure to switch OFF the power to the amplifier.
* Use with an amplifier having 8€? or below impedance speaker terminals.
* Be sure to only connect positive (+) wires to positive (+) terminals, and negative (—) wires to negative (—)
terminals.
Amplifier (not included)
HA
| OMEN:
o MES;
Speaker connection cables (not included)
Advertisement
