Table of Contents
Advertisement
Operating instructions
.
KENWOOD stereo CONTROL AMPLIFIER KC-207
GRaPac COUADIER
VOLUME CONTROL
—a
4
=
;
|
HEE
1soH: 00H:
thie
kite
GkMe
{Ski
Input selector switches
To listen to program source
Tape-to-tape dubbing
1. Press the POWER switch.
©
Dubbing from tape deck 2 to tape deck 1
2. Select the program
source
to be played with the input
1. Press the POWER
switch.
selector switches or TAPE-2 selector switch.
2. Press TAPE-2 selector switch and the input selector switch
When the SYSETM CONTROL connector on the rear pane!
other than TAPE-1.
is connected as shown in the figure on page 12, pressing
3. Set tape deck 2 to play and tape deck 1 to record.
the input selector switch sets the specified unit to play
4. To equalize the recording sound, press the EQ REC switch
mode.
and adjust the GRAPHIC EQUALZIER controls.
3. Play the program source.
(The operations 1~3 can be performed with the remote con-
4. Adjust the volume level with the VOLUME CONTROL.
troller.)
5. To equalize the listening sound,
press the ON/DEFEAT
switch and adjust the GRAPHIC EQUALIZER controls.
Notes:
(The operations
1~ 4 can be performed with the remote con-
1. Do not press TAPE-1
input selector switch during dubbing.
troller.)
2. To listen to the equalized recording sound, press the ON/DEFEAT
switch.
Note:
When the TAPE-2 selector switch is set to ON, the program source
selected
with
input selector
switch
cannot
be
heard
from
the
speakers. To listen to the program source other than tape deck 2, be
sure to set the TAPE-2 selector switch to OFF.
To
record
program
source
(TUNER,
CD,
PHONO, VIDEO-1/AUX, VIDEO-2)
1. Press the POWER switch.
2. Select the program source to be recorded with the input
selector switch
(TUNER,
CD,
PHONO,
VIDEO-1/AUX,
VIDEO-2).
When the SYSTEM CONTROL connector on the rear panel
is connected as shown in the figure on page 12, pressing
the input selector switch sets the specified unit to play
mode.
3. Play the program source.
4. Set tape deck 1 and/or tape deck 2 to record mode.
5. To equalize the recording sound, press the EQ REC switch
and adjust the GRAPHIC EQUALIZER controls.
6. To equalize the listening sound, press the ON/DEFEAT
switch.
(The
operations
1~4
and 6 can
be performed
with the
remote controller.)
Note:
The equalizer sound can only be recorded with tape deck 1.
Kc-207 (k) 11
Hide quick links:
Advertisement
Table of Contents
