Related Manuals for CHEFOOK CT74BGO1
Summary of Contents for CHEFOOK CT74BGO1
- Page 1 Instructions for installation, use e maintenance GAS KITCHENS CT74BGO1 CT76BGO1 01 2016...
- Page 2 CHARACTERISTICS Supplied by: Date: Customer Service: e-mail 0826_GB_99 - GAS KITCHENS 01/2016 2 · 16...
- Page 3 INDEX Diagram 6 Instructions for use 6.1 Safety, cleaning and repair rules Characteristics of the appliances 6.2 Start-up 6.2.1 Lighting and disconnecting flame burner without pilot Technical data 6.3 Lighting and shutdown of gas oven GN 1/1 6.4 Turning the appliance off in case of breakdown 4 Installation instructions 6.4.1 What to do in case of failure 4.1 Safety rules...
- Page 4 1 - DIAGRAM CT76BGO1 g ¡ ¢ £ ¤ ¥ ¦ § § § § § V § § T © 2 ! " # Gas 1/2" T U T U I © ¨...
-
Page 5: Characteristics Of The Appliances
THE APPLIANCE MUST BE INSTALLED BY QUALIFIED PERSONNEL. 20 mbar 3 - TECHNICAL DATA Model Description Dimensions in mm. (LxDxH) CT74BGO1 Gas range 4 burners - gas oven GN 1/1 800 x 700 x 900 51BS3545 Gas range 6 burners -... - Page 6 II2H3+ Construction type Air necessary for combustion Nominal thermal power Minimum thermal power 0.95 0.85 Overall thermal power (gas) Hour consumption G30/G31 kg/h CT74BGO1 17,6 1,95 1,44 24,6 CT76BGO1 2,73 2,02 Connection pressure Methane gas 2H 20 mbar Liquid gas 3+...
-
Page 7: Installation Instructions
4 - INSTALLATION INSTRUCTIONS 4.1 Safety rules data plate that the appliance is suitable and type-tested for the type of gas available. If the type of gas indicated on the data plate of the appliance does • Installation, modifications and maintenance of the appliance not correspond to the gas which is present, refer to the paragraph must be carried out by authorised personnel in compliance with 5.1.8 “Conversion and adaptation”. -
Page 8: Set-Up For Operation
5 - SET-UP FOR OPERATION 5.1 Preparation and Start-up 5.1.5 Power check for operation with liquid gas Check if the type of injectors used meet the data of the table 1. Before starting up the appliance, remove the protective wrapping. Check that the pressure reducer installed in the system has an outlet Then carefully clean the working surface and the external parts with pressure which is compliant with paragraph 5.1.2 "Check of power"... -
Page 9: Maintenance
5 - SET-UP FOR OPERATION Fig. 1 5.1.12 Setting reduced capacity power oven • Remove the grills, the flame spreaders and the bodies of the burners; Loosen screw (pos. 9 fig. 2) by two or three turns after having remo- •... -
Page 10: Replacing Parts
5 - SET-UP FOR OPERATION 5.3 Replacing parts 5.3.7 Thermocouple gas oven GN 1/1 All parts must be replaced by authorized technicians Unscrew the nut (pos. 20 fig. 2) and the nut (pos. 10 fig. 2) fixing only! the thermocouple on the cock and put in a new piece (pos. 17 fig. 2) install in reverse order. -
Page 11: Safety, Cleaning And Repair Rules
6 - INSTRUCTIONS FOR USE 6.1 Safety, cleaning and repair rules 6.3 Lighting and shutdown of gas oven GN 1/1 • This appliance is used for the preparation of meals at indus- Press and turn it to the left until position 7 the knob (pos. 14 fig. 2). trial level. -
Page 12: Warnings And Advice For Maintenance Of "Stain- Less Steel" Appliances
6 - INSTRUCTIONS FOR USE 6.6 Recommendations for the treatment of formed rust spots can be removed with slightly abrasive liquid soaps or fine-grained sand paper. Larger rust spots can be stainless “steel industrial” kitchens removed with 2-3% of hot oxalic acid solution. If these cleaning products do not do the job, a nitric acid (10%) treatment is 6.6.1 Useful information on “stainless steel”... - Page 13 6 - INSTRUCTIONS FOR USE 6.6.3 The 2002/96/EC (WEEE) Directive: information to users This informational note is meant only for Fig. A owners of equipment marked with the symbol shown in fig. A on the adhesive label featuring the technical specifica- tions applied on the actual product (the label also giving the serial number).
- Page 14 NOT S 0826_GB_99 - GAS KITCHENS 01/2016 14 · 16...
- Page 15 NOT S 0826_GB_99 - GAS KITCHENS 01/2016 15 · 16...
- Page 16 WARNING THE MANUFACTURER CANNOT BE HELD RESPONSIBLE FOR ANY INACCURACIES IN THIS BOOKLET DUE TO COPYING OR PRINTING ERRORS. DUE TO ITS POLICY OF CONTINUAL PRODUCT IMPROVEMENT, THE MANUFACTURER RESERVES THE RIGHT TO MAKE ANY CHANGES DEEMED NECESSARY. THE MANUFACTURER CANNOT BE HELD RESPONSIBLE IF THE INSTRUCTIONS CONTAINED IN THIS MANUAL ARE NOT OBSERVED.
Need help?
Do you have a question about the CT74BGO1 and is the answer not in the manual?
Questions and answers