Directed 6867T Replacement

Product Description

The 6867T control center is compatible with the following modules: DS4
and DS4+.

Mounting the Control Center

Once this replacement control center has been installed, all
Note
remote controls must be paired with your system. See Remote
Pairing for details and follow the instructions for your remote
control type.
The control center's position should be discussed with the vehicle owner
prior to installation since the antenna, with built-in status LED and Valet/
Program, must be visible/accessible to the customer.
The best position to locate the control center is centered high on the front
windshield. It can be mounted vertically or horizontally relative to the
windshield. Metallic window tint can also a ect range negatively, so this
should be a consideration when determining the mounting location.
After you determine the best mounting location, follow these steps:
Clean the mounting area with a quality glass cleaner or alcohol to remove
any dirt or residue.
Plug the cable into the control center.
Mount the control center with double-sided tape.
Route the cable down the window pillar to the control module and plug
the cable in the control module.
CABLE
CONTROL
MODULE
© 2017 Directed, All rights reserved.

Remote Pairing

Prepare the vehicle system to be Paired with a new remote
1. Open at least one vehicle door.
2. Turn the key to the ON position.
3. Within 5 seconds press and release the Control button on the Control
Center one time.
4. Within 5 seconds, press and hold the Control button on the Control
Center. The status LED begins flashing in single flash sequence and
the siren/horn sounds once to confirm the system is ready for remote
pairing. Release the button.
5. Locate your remote control model below and follow the instructions.
System Pairing will exit if:
• The ignition is turned o
• The open door is closed
• 60 seconds lapses with no actions
Note
: Make sure the remote to be paired with the system is set for the de-
sired Car 1 or Car 2 operation.
LCD Remote Control:
1. Press and hold the
Main Menu
2. Press the AUX or
3. Press and hold the
lease the
4. Press the
5. Wait several seconds for feedback as the remote generates a security
encryption and sends it to the Control Center. If pairing is successful
the siren/horn sounds and the remote emits several tones. The screen
displays if the Pairing is successful or failed with corresponding text. If
pairing fails repeat step 4.
To exit pairing mode on the remote:
• Press and release the
• Wait 30 seconds without pressing a command button on the remote.
Responder LED or Companion Remote Control:
1. Press and hold the
on solid. Release the
2. Press and hold the
comes on solid.
CONTROL CENTER
3. Press the
4. Wait several seconds for feedback as the remote generates a security
encryption and sends it to the Control Center. If pairing is successful
the siren/horn sounds and the 2-way remote emits several tones (the
companion remote does not generate tones). If pairing is not suc -
cessful press and release the
2 and 3.
To exit pairing mode on the remote:
• Press and release the
transmit LED shuts o .
• Wait 30 seconds without pressing a command button on the remote
control.
1
Replacement
Digital Control Center
AUX
button for 8 seconds, the remote beeps once,
AUX
is displayed. Release the button.
buttons until Pair is displayed.
AUX
AUX
button until the remote beeps 3 times then re-
AUX
button. The remote is now ready to pair with the system.
button.
AUX
button.
AUX
button for 8 seconds. The transmit LED will come
AUX
A U X
button.
until the transmit LED flashes 3 times then
AUX
button.
AUX
AUX
button once and then repeat steps
AUX
button once, then press and hold until the
N6867T--2017-11-30
6867T