One products OTB02 Installation And User Manual

OTB02
Installation and User Manual
+1 (310)-645-6400
www.one-products.com
Promounts
20218 Hamilton Ave,
Torrance CA 90502
Warnings
- Do not use rough textured cleaning tools or highly corrosive
cleaners when cleaning your LED Lights. These tools and
chemicals will damage the product. ONLY use a soft damp
cloth and non corrosive cleaners.
- Do not scratch the LED strips or use sharp objects on them.
- Do not permanently bend, twist, or screw through the LED
strips as this will damage the LED's internal components.
- Do Not pull or snap with excessive force, this will damage
the product.- If the product is damaged or wires are frayed
or damaged, do not use the product. If your product arrived
in this condition, contact us for a replacement.
- Recommended temperature is between 10°F to 120°F. Do
not use in extreme heat or cold.
- Once the product has come to the end of its life please
recycle the components. Ask your local retailer for proper
disposal methods.
Packaging Contains
- 1 Piece 70cm USB cable
- 1 Piece 24 key remote controller
- 3 Pieces 4-pin connection cables
- 6-pieces 4-pin connectors
- 4 piece 50 cm strip light, 30 LED per piece, 5v,
p65 waterproof 5050 RGB LED Strips
- 1 -
Installation Steps
Before beginning, look at your strips orientation. For correct
connectionmake sure to line-up the "+" to "+" between
strips and "->" to "+" whenusing the connection cables.
See below for example:
*IF the strips are not connected properly they will not work or appear dull.
1. Clean the surface of residue and dust
- 2 -
2. Remove the protective lm covering the adhesive backing
on your LED Strips
3. Place the LED strips in the location you desire, pressing
rmly and sliding your nger along the strip to ensure a
secure attachment.
- 3 -