Related Manuals for Tisira AGITBG Series
Summary of Contents for Tisira AGITBG Series
- Page 1 AGITBG RANGEHOOD INSTALLATION INSTRUCTIONS AGITBG 520 EAN #9351116000134 AGITBG 850 EAN #9351116000141 www.tisira.com...
-
Page 2: Table Of Contents
BEFORE YOU INSTALL LINE DRAWINGS DUCTING AND CLEARANCES INSTALLING THE RANGEHOODS USING THE RANGEHOOD / MAINTENANCE REPLACING THE LED LIGHT WIRING DIAGRAM WARRANTY INFORMATION... -
Page 3: Before You Install
BEFORE YOU INSTALL - DUCTING INFORMATION WARNING The appliance must be installed and connected to the power supply only by a qualified technician. • There should be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room) •... -
Page 4: Line Drawings
SM 927 LINE DRAWINGS... -
Page 5: Ducting And Clearances
DUCTING AND CLEARANCES operations, the appliance needs to be switched off. If the appliance is not provided with a non-separable flexible cable and plug, or with another device ensuring omnipolar disconnections from the grid, WARNING with an opening distance between the contacts of at least 3mm, then such disconnecting devices must be Min. -
Page 6: Installing The Rangehoods
AGITBG INSTALLATION To install the appliance please respect the follow instructions: WARNING: Failure to install the screws or fixing • The appliance must be installed by qualified device in accordance with these instructions technicians. may result in electrical hazards. In order to avoid damage to the electronic parts of the appliance, please do not use additional NOTE screws. - Page 7 NOTE • To make it easier to install the rangehood inside the cabinet, it is recommended to remove the glass. Unscrewing the four M3x10 screws as shown in Fig. 3. (Fig.5) (Fig.3) WARNING The rangehood is quite heavy, so two people will be needed for installation.
-
Page 8: Using The Rangehood / Maintenance
MAINTENANCE USING THE RANGEHOOD • Accurate maintenance guarantees good AGITBG (fig. 6) functioning and long-lasting performance. A: Motor switch on speed 1/off - (low/simmer) • Particular care is due to the grease filter panel. It B: Motor switch on speed 2 - (general cooking) can be removed by pushing its handle toward the C: Motor switch on speed 3 - (high power) back side of the rangehood and pulling the filter... -
Page 9: Replacing The Led Light
REPLACING THE LED STRIP ON THE AGITBG 2. Take out the LED light from its connector and 1. Before replacing the LED light, switch off the replace. (Fig 7c - d) rangehood, then - by using appropriate tools - • To find the correct LED light, please contact remove the LED light from its slot. -
Page 10: Wiring Diagram
WIRING DIAGRAM... -
Page 11: Warranty Information
Your Warranty Register now to qualify for your Warranty These Terms and Conditions apply only to Ariston This warranty will not apply where: Where the appliance, the subject of a warranty products distributed in Australia and New Zealand The fault is caused by accident, misuse, claim or repair, is used or installed more than by Arisit Pty Limited. - Page 12 Dear Customer, Thank you for choosing this appliance. We are sure that it will provide you with many years of excellent service. At Arisit Pty Limited we are dedicated to ensuring that our customers receive the best possible after-sales care. The Arisit ‘Protection Plan’...
Need help?
Do you have a question about the AGITBG Series and is the answer not in the manual?
Questions and answers