Panasonic RX-DT770 Operating Instructions Manual page 2

Dear Customer
Thank you for purchasing this product.
For optimum performance and safety, please read these operating
instructions carefully.
THE FOLLOWING PHRASES ARE APPLIED ONLY FOR U.S.A.:
CAUTION:
The model number and seria! number of this product can be
found on either the back or the bottom of the unit.
Please note them in the space provided below and keep for
future reference.
MODEL NUMBER RX-DT770
SERIAL NUMBER
User memo:
DATE OF PURCHASE
DEALER NAME
DEALER ADDRESS
TELEPHONE NUMBER
CAUTION:
TO PREVENT ELECTRIC SHOCK MATCH
WIDE BLADE OF PLUG TO WIDE SLOT,
FULLY INSERT.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELEC-
TRIC SHOCK, DO NOT EXPOSE THIS APPLI-
ANCE TO RAIN OR MOISTURE.
CAUTION!
THIS PRODUCT UTILIZES A LASER. А
USE OF CONTROLS OR ADJUSTMENTS OR PER-
FORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZ-
ARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND. DO NOT REPAIR
YOURSELF. REFER SERVICING TO QUALIFIED
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE SCHEWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SEHVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the
user to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may
be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the pre-
sence of important operating and maintenance
(servicing) instructions in the literature accom-
panying the appliance.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmfu! interference to radio commu-
nications. However, there is no guarantee that interference
wili not occur іп a particular installation. If this equipment
does cause harmful interference to radio or television recep-
tion, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interfer-
ence by one of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and re-
ceiver.
* Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician
for help. |
FCC Notice: This system complies with new Part 15, except
for the radio receiver, which complies with old Part 15, Subpart
C of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference re-
ceived, including interference that may cause undesirables
operation. The radio receiver is not subject to above item (2).
Any unauthorized changes or modifications to this equipment
would void the user's authority to operate this device.
Supplied Accessories
Please check and identify the supplied ac-
cessories.
(Only for U.S.A.)
To order accessories call MSC Accessory
Dept. 1-800-332-5368.
[|] AC power cord (Polarized) .....................................
(SJA172)
Е Remote control transmitter
(EUR643824)
Use numbers indicated in parentheses when asking for re-
placement parts.