Onkyo TX-SV525 Instruction Manual page 29

TV antenna VCR VCR (for recording) Monitor TV
OUTPUT
Recording of a TV broadcast and FM broadcast (simulcast) is pos-
sible when two VCR are used.
1. Receive the TV broadcast using the VCR tuner.
2. Press the VIDEO-2 or -3 input selector to set the picture to
VIDEO-2 or -3.
3. Press the FM Input Selector and tune in the FM simulcast
using a preset button or the tuning selectors.
The picture will be sent to the monitor TV and the FM stereo
sound to the speakers connected to this unit.
4. To record the TV picture with FM sound, receive the TV
ae broadcast using one VCR (connected to VIDEO-2 (or 3)) and
Rear panel of TX-SV525/R begin recording on the other VCR (connected to VIDEO-3
(or 2)).
The program can be monitored during recording.
FM antenna
1. Press the Input Selector button to select the VCR (VIDEO-
1, 2 or 3) that will be used to play the video.
2. Press the REC/PAUSE button on the VCR (VIDEO-2 or 3)
that will be doing the recording.
3. Press the REC OUT button.
REC OUT 4. Press the Input Selector button (CD, PHONO, FM, AM,
TAPE-1 or TAPE-2) that will provide the audio source.
5. Start operation of the equipment.
The picture will be left as is. Only the audio will be changed.
The picture will be recorded from the video source, and the
sound from the audio source.
Listening to devices connected to this unit in
another room
The TX-SV525/R allows you to listen to the desired performance in another room (sub room) while listening to the playback of a device located
in the main room. To do this, connect the speakers in another room to the Front SPEAKERS REMOTE terminals on the TX-SV525/R.
Remote control from another room can be done by employing the Multiple Room Remote System (MR). Refer to the connections for Multiple
Room Remote Control. Be sure to operate the remote control pointing it at the Remote Sensor.
MR off button (MR OFF) and indicator
Use this button for tape recording or for the Surround sound modes. It is used to disable control of the MIRE, system via the remote control in
another room. Pressing this button will illuminate the indicator, and control from another room will be disabled. Pressing the button again will
turn the indicator off, and control from the another room will be enabled.
Using the remote control
You can use the remote control supplied with this Tuner Amplifier to operate the source devices selected for the multi-source if they are an
ONKYO CD or cassette deck bearing the RI mark.
It you require a second remote control for the sub room, there is a remote contro] RC-MR 1H for the sub room, which is sold separately.
Installation of the Remote Sensor and the Remote Emitter is required to control non-ONKYO devices from another room (sub room). Operate
the remote control included with the device by directing the remote control toward the remote sensor installed in the sub room.
If a problem occurs, carry out the same operation on this unit's Front panel controls to verify that the problem is with the remote control.
If there is no problem when operating this unit directly, check the batteries in the remote control first before assuming that there is a controller
malfunction.
NOTES:
e {f remote control operations are done in another room, the source on the Input Selector may change. or any recording being done on this unit
may be interrupted.
Press the MR OFF button to disable control from another room. (The MR OFF indicator will be illuminated. )
@ Some non-ONKYO remote controls cannot be used.
29