Table of Contents
Advertisement
NAVIGATION
IMPORTANT SAFETY
INSTRUCTIONS
ACKNOWLEDGEMENTS
INTRODUCTION
OVERVIEW
QUICK START
UPDATING THE FIRMWARE
CONNECTIONS
SOUND DESIGN &
PROGRAMMING
EFFECTS
PERFORMANCE CONTROL
SECTION
RIBBON CONTROLLER
ADDITIONAL CONTROLS &
PARAMETERS
USING THE MODULATION
MATRIX
VOICE ASSIGN
ARPEGGIATOR &
SEQUENCER
GLOBAL SETTINGS
FILE MANAGEMENT
HOW-TO GUIDE
CHEAT SHEET
MIDI SPECIFICATIONS
GLOSSARY
SUPPORT INFORMATION
The left-right phase when LR PHASE is set to 100% (2π).
SPREAD: When binaural mode is disabled, the LR PHASE fader turns
into a pan spread control, allowing you to adjust how far the non-binaural
voices are spread in the stereo panorama. At its lowest setting, all voices
are centred. At its highest setting, all voices are alternately hard-panned
between the left and right channels.
In SOLO and LEGATO modes, non-binaural voices are not panned.
In these instances, SPREAD only controls phase offsets for LFO 1.
WAVEFORM: In low-frequency mode, this rotary switch allows you to
choose from four different waveforms: triangle, reverse sawtooth, sample
& hold or square.
LFO 1 waveforms.
• Triangle can be used to produce vibrato effects as it alternates equally
between positive and negative values. This is a bipolar waveform.
• Reverse sawtooth and square generate positive values that allow for
pulsating sounds or modulations. The square wave can also be used to
create trill-like effects at higher rates.
• Sample & hold produces random positive or negative values for the
duration of one duty cycle. This waveform can be used to create either
subtle movements or wild effects. With RATE set to its highest value,
sample & hold will generate a white noise signal.
UDO Super Gemini — Owner's Manual
56
Advertisement
Table of Contents
