Advertisement
Smartdiag2 is a telematic device equipped with Cellular and GNSS modules with internal antennas, gyroscope, accelerometer and
Bluetooth tranceiver.
Please refer exclusively to the information indicated in this manual for installation activities.
The device was designed to be installed inside the passenger compartment room only.
Please do not remove the warranty seals or attempt to open the device or its accessories.
Please do not attempt to modify or use the device outside of the scopes foreseen
Avoid device contact with water and dirt (dust)
The manufacturer declines every responsibility for damages caused to goods or persons due to a misuse of the device.
Your enclosed device plugs into the On Board Diagnosis (OBD) port of your
vehicle (included in all 2001 or newer vehicles).
Please follow the instructions below to install the device.
a) Locate the OBD port in your vehicle. This port is usually located under the
dashboard on the driver's side and may have a cover – the picture shows
the typical vehicle OBD port location.
b) Plug the device firmly into the OBD port – the picture shows how it works.
If it should not be possible to install directly on the OBD port, follow the instructions in the following chapter.
c)
Wait a few seconds for the LED lights to turn ON, confirming successful installation.
NOTE: the device initialization procedure work better if the vehicle is outside in an open area
with a good Cellular signal and satellite reception.
Title: User Manual Smart Diag 2
Rel: 1.1
DESCRIPTION
WARNINGS
DEVICE POSITIONING
Pag. 2 a 5
Advertisement
