Advertisement
Quick Links
Parts Included:
One rubber air hose tube
A
A
Steps to disassemble the pump and replace
rubber air hose set:
1. Use a utility knife to cut the sticker
along the gap in the main body.
2.
Use the Phillips head screwdriver to
remove the four screws on the bottom
of the pump. Place the four screws
safely to the side.
ChampionSports.com facebook instagra youtube
Rubber Air Hose Tube Replacement
EP1500
Required Tools:
NOT INCLUDED
One zip tie
B
One Phillips head screwdriver
C
One utility knife
D
One pair of diagonal cutting
E
pliers
One pair of spring clamp pliers
F
B
C
D
E
888.980.1200
F
One Champion Way, Marlboro, NJ 07746
1
Advertisement
Summary of Contents for Champion Sports EP1500
- Page 1 Rubber Air Hose Tube Replacement EP1500 Parts Included: Required Tools: One rubber air hose tube NOT INCLUDED One zip tie One Phillips head screwdriver One utility knife One pair of diagonal cutting pliers One pair of spring clamp pliers Steps to disassemble the pump and replace rubber air hose set: 1.
- Page 2 Rubber Air Hose Tube Replacement EP1500 3. Use the Phillips head screwdriver to remove the two screws from the wire buckle. Place the buckle piece and two screws safely to the side. 4. Use the Phillips head screwdriver to remove the six screws on the lower body of the pump.
- Page 3 Rubber Air Hose Tube Replacement EP1500 6. Use the Phillips head screwdriver to remove the two screws holding the pressure gauge plate. Place the plate and two screws safely to the side. 7. Pull out the red wire from the switch and then remove the motor unit.
- Page 4 Rubber Air Hose Tube Replacement EP1500 9. Use the diagonal cutting pliers to nudge the rubber air hose tube until it starts to loosen. Then, gently pull the tube off the valve by hand. 10. Insert the replacement rubber air hose tube through the spring restraint.
- Page 5 Rubber Air Hose Tube Replacement EP1500 12. Assemble the parts: Return the motor to its position. Snap the three-way connector into place. Plug the red wire back into the switch. Place the fan blade in the centered in the fan cover.
- Page 6 Rubber Air Hose Tube Replacement EP1500 15. Replace the cover to the body. Using the Phillips head screwdriver, replace and tighten the six screws. 16. Pull the power cord through the slot to hold it in place. Do not pull it too loose or too tight.