Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for WALLISS ZP-0101
-
Page 2: Table Of Contents
Table of contents Safety warnings Packling List Technical parameter Product description Charger use Operation instructions Adjust chain Replace chain Maintenance Warranty description... -
Page 3: Safety Warnings
Safety warnings Work area security a) Keep the work area clean and well lit. Cluttered or dark areas can cause accidents. b) Do not operate power tools in explosive environments, such as in the presence of flammable liquids, gases, or dust. Power tools can create sparks that may ignite dust or smoke. c) Keep children and bystanders away when operating power tools. -
Page 4: Packling List
Packling List Name Quantity Power chain saw Chain Guide plate sleeve Lubricating oil Bottle Battery Charger Technical parameter Modle ZP-0101 Battery Voltage Output speed 5600RPM Chain saw speed 10.7m/s Bar Length 6” Chain type 3/8”... -
Page 5: Product Description
Product description Guide Chain Chain Baffle High quality chain Locking knob Adjusting knob Manual oil pump Protection Swtich Power Switch Non-Dilp Handle Lithium Battery Cancel button Check button Indicating LEDS... - Page 6 Battery Packing:Pay attention to Button press and pull put the alingning slots inserts battery pack Note: ● The batteries produced by our company must be used, ● The battery is fully charged, please unplug the power. ● The battery has temperature protection, low voltage protec- tion and over current protection.
-
Page 7: Charger Use
Charger use Must use the charger produced by our company, The charger can only be used when the battery of the same voltage is inserted Mentioned in the matter. ● Plug in the power indicator light green, and when the battery is charging, the indicator light is red, charging the full power indica- tor is green ●... -
Page 8: Operation Instructions
Operation instructions Starting device Note ● After the installation is complete, start the machine with no load first and observe the normal operation of the machine. First Hold on the ● It is not advisable to cut too hard, Protection Swtich according to the actual cutting situation, first small and then large. -
Page 9: Replace Chain
Replace chain 1. Remove the sprocket cover. Note ● Install the chain according to the requirements of the operation diagram. Note: Unplug the battery pack during installation and removal of the guide 2.Put the chain into the guide plate plate. 3. -
Page 10: Maintenance
Maintenance To ensure the safety of use,only the original parts can be used. Repair work functions not mentioned in this specification are performed by the service center. To ensure safe use, only original parts can be used. Please close the equipment before starting the chair repair. Clear the connec- tion between the battery and the plant and store the battery in a safe pack- age. -
Page 11: Warranty Description
Warranty description The warranty period of this product is 3 months, this clause does not include the following points: Any natural wear and tear, overload wort Damage caused by lack of routine maintenance and maintenance. Improper use and so on artificial damage. Damage caused by improper transportation after living. - Page 12 ZP-0101...