Honda Accord Coupe 1995 Online Reference Owner's Manual page 148

Cooling System
RESERVE TANK
HOLDER
RESERVE TANK CAP
4. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
5. When the coolant stops draining,
tighten the drain plug in the
bottom of the radiator. Apply non-
hardening sealant to the drain bolt
threads and reinstall the bolt in
the engine block. Tighten it
securely.
Maintenance
FILLER NECK
Fill up to here
6. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
With manual transmission:
5.4 (1.43 US g a l , 1.19 Imp gal)
With automatic transmission:
5.3 (1.40 US g a l , 1.17 Imp gal)
7. Pour coolant into the radiator up
to the base of the filler neck.
BLEEDER BOLT
8. Loosen the bleeder bolt on top of
the engine. Tighten it again when
coolant comes out in a steady
stream with no bubbles.
9. Refill the radiator to the base of
the filler neck. Put the cap on the
radiator, only tighten it to the first
stop. Start the engine and let it run
until it warms up (the radiator
cooling fan comes on at least
twice).