Beko WKE 15080 D Manual page 29

Function Selection
Depending on the selected program, the
selectable auxiliary functions are selected
by pressing the each function's button.
The light of the selected function comes
Auxiliary Functions
Prewash
To wash the very dirty laundries, you can
use this function in the cotton and
synthetic programs.
Rinse Plus
You can increase the number of the
current rinsing cycles by using this
function. Thus, the risk of the sensitive
skins get effected by the detergent
remaining on the laundry is reduced.
Spin Speed Reduction
Using this button, you can select final spin
speed upto 800 rpm. If you do not want to
apply spinning to your clothes, select "No
Spin" option.
Child Lock
"This machine is equipped with a child lock
in order to prevent the program flow to be
affected when the buttons are pressed
during washing cycles. In order to enable
the child lock, press and keep pressed the
1st and 2nd auxiliary function buttons from
the left at the same time for 3 seconds.
The light of the 1st auxiliary function button
will flash continuously.
After the program completes, it is
necessary to disable the child lock in order
Program Flow
After the machine starts to operate, the
related light in the program follow-up
indicator comes on according to the
selected program.
When a step is complete, the light of the
previous step goes off and the light of the
related step comes on. When On/Off button
is pressed, the "Door" light comes on.
After the washing program is selected,
"Washing" light on the program follow-up
indicator comes on when the "Start/Pause/
Cancel" button is pressed.
When the program ends "End" light comes
11
on. Since it is not possible to select some
of the auxiliary functions together, one of
them becomes off when the other one is
selected.
to initiate a new program or interfere the
program. Therefore, when the same
buttons are pressed for 3 seconds, light of
the second auxiliary function will go off.
on. After the program is complete, the
machine will not allow you to open the door
for a while for your safety. If you want to
open the door meanwhile, the door will not
open and the "Door" light will flash. After
the door lock is deactivated the "Door" and
"End" lights will come on. Now you can
open the front door. You can switch your
machine in to the "Pause" mode by press-
ing the "Start/Pause/Cancel" button while
your machine is operating.
In this case, "Start/Pause/Cancel" light will
EN