Summary of Contents for PCB Piezotronics ICP W138A06/-0015
Page 1
Model W138A06/-0015 ICP® Pressure Sensor Installation and Operating Manual For assistance with the operation of this product, contact PCB Piezotronics, Inc. Toll-free: 800-828-8840 24-hour SensorLine: 716-684-0001 Fax: 716-684-0987 E-mail: info@pcb.com Web: www.pcb.com...
Page 2
Piezotronics, user servicing or repair is critical test. not recommended and, if attempted, may void the factory warranty. Routine PCB Piezotronics maintains an ISO- maintenance, such as the cleaning of 9001 certified metrology laboratory and electrical connectors, housings, and offers calibration services, which are...
Page 3
50% of the general contact numbers are: replacement cost returned item(s). PCB will provide a price PCB Piezotronics, Inc. quotation replacement 3425 Walden Ave. recommendation for any item whose Depew, NY14043 USA repair costs would exceed 50% of...
Page 5
Component Name Hazardous Substances Lead Mercury Cadmium Chromium VI Polybrominated Polybrominated (Pb) (Hg) (Cd) Compounds Biphenyls Diphenyl (Cr(VI)) (PBB) Ethers (PBDE) Housing PCB Board Electrical Connectors Piezoelectric Crystals Epoxy Teflon Electronics Thick Film Substrate Wires Cables Plastic Solder Copper Alloy/Brass This table is prepared in accordance with the provisions of SJ/T 11364.
Page 6
OPERATION MANUAL FOR Series 138 Series 138 Standard Length, with Lead Wire Hole for Attaching Weights Series 138 Short Length, One-Piece Molded Closed-End Tube Series 138 are used by the military for underwater INTRODUCTION explosive testing, commercial use in gasoline tanks and transformer shock wave applications.
Page 7
OPERATION MANUAL FOR Series 138 Some models of the Series 138 feature a tygon tube PCB Model 070A03 adaptor can be used to adapt the closed at one end with conical-shaped delrin plug. 10-32 micro jack on the 138 to a BNC jack. A heavier coaxial cable (eg.
OPERATION MANUAL FOR Series 138 The steel wire can have a weight attached to it to If indicator is in green section of indicator panel, the submerge the entire assembly. Tape or attach the IC amplifier is producing proper bias (+8 to 14 VDC), cable connections are normal and the system coaxial cable loosely to the steel wire at ~one foot intervals.
100 °F. Do not apply voltage to sensor without current-limiting diodes or other current protection. Do not apply more than 20 mA of current to the sensor. ®ICP is a registered trademark of PCB Piezotronics, Inc. Drawing Number: 21102 Revision: NR...
Page 10
3425 Walden Avenue, Depew, NY 14043 All specifications are at room temperature unless otherwise specified. In the interest of constant product improvement, we reserve the right to change specifications without notice. ® is a registered trademark of PCB Piezotronics, Inc.
Need help?
Do you have a question about the ICP W138A06/-0015 and is the answer not in the manual?
Questions and answers