Advertisement
Quick Links
Advertisement
Related Manuals for Tool Shed TSDSF
Summary of Contents for Tool Shed TSDSF
- Page 1 STUD FINDER TSDSF www.thetoolshed.co.nz...
-
Page 2: Product Details
PRODUCT DETAILS PRODUCT ToolShed Stud Finder MODEL NO. TSDSF NOTE: This manual is only for your reference. Due to the continuous improvement of the ToolShed products, changes may be made at any time without obligation or notice. WARRANTY This product may be covered under the ToolShed warranty. For more information see our Terms &... -
Page 3: Table Of Contents
CONTENTS Product Details ................2 Specifications ................. 4 Product Identification ..............5 Safety Guidelines ................7 Operation ..................9 Maintenance, Service & Cleaning ..........12 www.thetoolshed.co.nz... -
Page 4: Specifications
SPECIFICATIONS Maximum Detection Depth Iron – containing metal 1.5inches / 38mm Non-ferrous metal (copper) 1inch / 20mm Live wires 1.5inches / 38mm Foreign body (usually wood) 10mm / 20mm / 38mm Automatic Shutdown Time Approx. 5 minutes Working Humidity Range Metal mode 0-85% RH Foreign body mode... -
Page 5: Product Identification
PRODUCT IDENTIFICATION Screen Foreign body detection button On/Off switch Metal detection button Metal detection area Main detection area Product labels Battery compartment www.thetoolshed.co.nz... - Page 6 CENTER indicator Battery power icon Left EDGE icon Left signal area Foreign body mode Metal mode AC mode Buzzer icon Right EDGE icon Signal area on the right www.thetoolshed.co.nz...
-
Page 7: Safety Guidelines
IMPORTANT INFORMATION GENERAL SAFETY GUIDELINES WARNING READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS. Failure to follow instructions and warnings could lead to serious injury, electric shock, or fire. Save ALL warnings and instructions for future reference. The detection results will be affected by the material, size, and condition of the object or surface. - Page 8 IMPORTANT SAFETY WARNINGS - In some cases, the tool may not be able to accurately indicate the presence of live wires in the wall if the internal equipment fails or is improperly operated. Therefore, it should not be relied solely on to identify the presence of dangerous live wires.
-
Page 9: Operation
OPERATION Install / Replace the Batteries The battery is located in the battery bin. When the detector is not going to be used for a long period of time, the batteries must be removed from it. Long periods of time can cause the battery to corrode and discharge which can damage the device. - Page 10 Basing on the thickness of the wall that you wish to detect within, press the mode switch to enter the appropriate depth of foreign body detection mode. At this time, the current detection mode will appear on the screen, and the instrument will automatically calibrate the screen signal area to clear.
- Page 11 Detection of Metal Objects (steel bars, wires, copper tubes) The maximum detection depth of metal is 38mm. Short press the metal detection button to enter metal detection mode. Wait until the instruments signal area is cleared and automatic calibration is completed before operation. To operate the detector in this mode, hold it flat on your surface and slowly move it to the left or right.
-
Page 12: Maintenance, Service & Cleaning
Maintenance, Service, and Cleaning Use a dry soft cloth to remove dirt from the stud finder. Do not use detergents or solvents. Do not put any labels or nameplates on the front and rear areas of the detector. Do not paste metal nameplates to the stud finder. Use the accompanying protective case to store and carry the detector.
Need help?
Do you have a question about the TSDSF and is the answer not in the manual?
Questions and answers